Connecting To A Network - JVC VN-C1U - Digital Ethernet Color Camera Instructions Manual

2. Connecting to a network

Turn on the power of only one VN-C1U.
Connecting VN-C1U to a network and turning on the power will connect the unit to a network with the
following IP address.
Factory set IP address : 192.168. 1. 2
To retain electromagnetic compatibillity,use the provided
ferrite core when connecting to VN-C1U.
Note
All VN-C1U at the time of shipment have the same IP address. Correct
access cannot be obtained when turning the power of multiple units on at the
same time due to overlap of ID addresses. Always turn on the power of one
unit at a time and proceed with the following VN-C1U IP address setup.
In the case where doubling of IP addresses occur, correct access may not be
achieved unless waiting for at least 10 minutes after making correction, or
turning off all network devices then turning them back on.
5
Wound 3x
Special adapter
Install the ferrite core within 50mm
of VN-C1U-side connector.
Shielded
modular cable
When connecting to a HUB, use a straight cable.
When connecting directly to a PC, use a crossing cable.
To power outlet
Ferrite core