Connecting To A Network - JVC VN-C2WU - V-networks Pan/tilt Camera Instructions Manual

2. Connecting to a network

(Ethernet, Fast Ethernet through Auto negotiation HUB).
Turn on the power of only one VN-C2WU unit.
When network connection is completed and the power is turned on, the VN-C2WU unit will be
connected to the network at the following IP address.
Factory set (Default) IP address : 192.168. 0. 2
Caution Caution
All VN-C2WU units are set to the same IP address at the factory; therefore, if
the power of multiple VN-C2WU units is turned on at the same time, correct
access will not be possible. Always turn the power on for only one unit at a
time. If duplication occured, perform the proper processing, wait for 10 min. or
more or turn off the power of all units on the network and then turn the power
on again; otherwise, correct access will not be possible.
5
Round 3x
Optional adapter
Install the ferrite core within 50mm
of VN-C2WU-side connector.
Optional shielded
LAN cable (10BASE-T)
When connecting to a HUB, use a straight cable.
When connecting directly to a PC, use a cross cable.
To power outlet
Ferrite core