Dip Switch Functions - Honeywell NightHawk HCD82484 User Manual

4. Your camera comes set up from the factory. If you need to make
minor adjustments, refer to the procedures below to adjust the
switch settings, focus, and vertical phase (24 VAC).
Caution Honeywell does not recommend changing the dip
switches other than the vertical phase and focus
controls. These dip switches are factory configured
for optimal performance. If further adjustments are
required please feel free to contact Honeywell
Customer Service or authorized service personnel.
Caution During the entire time the bezel is off, ensure that
the camera board, lens, and LEDs are kept intact
and free from dust.
5. Slide the bezel enclosure over the camera and rotate the enclosure
until it slides into place. Tighten the security screws with the Allen
key supplied, to keep the bezel in place.
Figure 3
Top locking screw
adjusts focus
Line lock controls push buttons

Dip Switch Functions

Figure 4
Legend
1. AWB/ATW
2. AGC
3. IRIS
4. BLC
5. FLON
Rev 1.00
Camera Board
Factory Default Settings
1 2
6
Iris level adjustment
Bottom locking screw
adjusts focal length
ON
OFF
3 4 5
Document 900.0391
09/05