Desa VGC18NR/PR Owner's Operation And Installation Manual page 18

INSTALLATION
Continued
2. Place middle log in front of U-burner and against
the edges of plate as shown in Figure 24.
3. Place front left log (#3) onto pan burner be-
tween log #2 and grate. Back of log #3 should
fit against front of log #2. Place front right log
(#4) onto pan burner between log #2 and grate.
Log #4 has notched end to fit over end of pan
burner as shown in Figure 25. Back of log #4
should fit against front of log #2.
4. Place log #5 as shown in Figure 26. Top will
fit onto right pin on back log (#1). Front of log
will fit onto right pin on log #2.
5. Place left crossover log (#6) over left pins
on logs #1 and #2 as shown in Figure 26,
page 18.
6. Add embers to front flat burner. Gently remove
embers from the bag using gloves or tweezers.
(This material is a skin irritant. Gloves or
tweezers are recommended to prevent skin
irritation). Separate the pieces. Place ember
pieces, one at a time, over surface of flat front
burner (see Figure 27, page 19). Do NOT place
ember material anywhere else on the unit.
Use only ember material supplied with unit.
Excessive ember material may produce
carbon monoxide or soot.
7. Place right crossover log (#7) onto pin in log
#5 and resting on grate as shown in Figure 27,
page 19.
8. Add lava rock and small decorative logs
around base of heater if desired. DO NOT
place rock or additional logs on front
burner or on logs. Placing any material on
unit other than ember material on front burner
may result in production of carbon monoxide
or soot. Use lava rock to hide wires from
switch/log to control valve. Place switch/log
so the switch is easy to access.
Figure 23 - Installing Log #1
18
1
www.desatech.com
Figure 24 - Installing Log #2
3
Figure 25 - Installing Logs #3 and #4
6
Figure 26 - Installing Logs #5 and #6
2
4
5
119162-01A