Desa VGC18NR/PR Owner's Operation And Installation Manual page 17

INSTALLATION
Continued
9. Connect wires from hardware pack (with
remote receiver bracket) to control valve
at the TPTH and TH locations as shown in
Figure 20. Connect other ends of these wires
to remote receiver wires. Note: Make sure
excess wire does not interfere with burner or
pilot.
10. If heater was removed from fireplace before
installation of remote accessory, see Installing
Heater Base Assembly on page 12 to reinstall
heater into fireplace. Test gas connection for leaks
(see Checking Gas Connections, page 15).
11. If logs were removed from heater for install
remote accessory, replace logs (see Installing
Logs, Embers and Lava Rock, page 17).
Control Valve
Figure 20 - Connecting Wires
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand-held remote control set. One battery must be
installed in the receiver and one in the hand-held
remote control unit. Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the back
of the receiver (see Figure 18, page 16).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.
119162-01A
Red Wire to
Red Wire on
Receiver
White Wire to
White Wire on
Receiver
www.desatech.com
Battery Cover
Terminal
Wires
9-Volt Battery
Figure 21 - Installing Battery in Hand-Held
Remote Control Unit
INSTALLING SWITCH
The AUTO/OFF/ON switch for this log set will
need to be installed into the small single log ac-
companying this log set.
1. Slip wires of switch assembly through hole in
center of log (see Figure 22).
2. Snap switch assembly into place.
3. Attach wires to control valve as shown in
Figure 20.
Figure 22 - Installing AUTO/OFF/ON
INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place rear log on bas assembly as shown in Fig-
ure 23, page 18. The log will fit over right end
of burner and rest in the middle of U-burner.
Remote
Control
Battery
Unit
Housing
Switch
Switch
1