Related Manuals for Matheson FM-1050
Summary of Contents for Matheson FM-1050
- Page 1 FM-1000/FM-1050 FLOWMETERS Operation Instructions READ AND COMPLY WITH THESE INSTRUCTIONS BEFORE INSTALLING, OPERATING, OR SERVICING INT-0131 Rev C...
-
Page 3: Table Of Contents
Table of Contents I. SERVICE ......................1 II. LIMITED WARRANTY ................... 2 III. USER RESPONSIBILITY ................. 3 IV. GENERAL ....................4 V. INSTALLATION ..................... 4 VI. MOUNTING ....................5 VII. OPERATION ....................5 VIII. DISASSEMBLY AND REASSEMBLY ............. 6 IX. CLEANING PROCEDURE ................7 X. -
Page 5: Service
(All repairs must be made by MATHESON or an assigned and approved facility to maintain any warranties or guarantees). If the unit is under an applicable warranty, return the unit to MATHESON for repair or replacement. To arrange for warranty service, call 1-800-828-4313 and ask for the Warranty Administrator. -
Page 6: Limited Warranty
MATHESON's sole discretion, the equipment or part which is telephonically reported to be a problem to the local MATHESON Branch Location, and which if so advised, is returned with a written statement of the observed deficiency, not later than seven days... -
Page 7: User Responsibility
Should such repair or replacement become necessary, MATHESON recommends that a telephonic or written request for service advice be made to the MATHESON Equipment Engineering Group in Montgomeryville Pennsylvania or to the nearest MATHESON branch location. -
Page 8: General
IV. GENERAL MATHESON flowmeters combine construction and performance features essential to accurate low flow measurement. This information is intended as a guide to efficient use; careful compliance should result in long and useful service. V. INSTALLATION Immediately after unpacking, inspect unit for any damage incurred during shipment. -
Page 9: Mounting
VI. MOUNTING The meter must be mounted in a vertical position with the inlet (lowest end of the scale reading) at the bottom. Attitude of more than 5° from the vertical will affect the accuracy of the meter. Panel mounted meters should be installed in position prior to connection to process piping. -
Page 10: Disassembly And Reassembly
VIII. DISASSEMBLY AND REASSEMBLY A 5/32” hex wrench fits the recessed seal screw located at one end of the meter. Turn the hex wrench counterclockwise until the seal screw is flush with the inside surface of the end fitting. NOTE: If the meter does not have a tube enclosure then the tube must be held to prevent it from falling from the meter frame. -
Page 11: Cleaning Procedure
IX. CLEANING PROCEDURE (Please notify the factory if cleaning for oxygen service is required) A. TUBE AND FLOAT CLEANING Remove the float stops. Take care to avoid chipping the inside edges of the tube. Flush the inside of the tube with solvent (without wax or inhibitors, i.e. glycols). - Page 15 The parts listed below are applicable to MATHESON FM-1000 and FM-1050 flowmeters. Recommended spare parts are indicated by *. 65 MM 150 MM Part Number Description MARK TUBES TUBES J000-J099 E100-E199 J100-J199 E200-E299 MAAT-0202-___ ADAPTOR, VALVE, 1/8" NPT** J200-J299 E300-E399 MAAT-0201-___ ADAPTOR, SEAL, 1/8"...
- Page 16 Copyright 2019 Matheson Tri-Gas, Inc. All Rights Reserved. All contents of this document are subject to change without notice and do not represent a commitment on the part of Matheson Tri- Gas, Inc. Every effort is made to ensure the accuracy of this information. However, due to differences in actual and ongoing operational processes and product improvements and revisions, Matheson Tri-Gas, Inc.
Need help?
Do you have a question about the FM-1050 and is the answer not in the manual?
Questions and answers