Fujitsu 5015C - fi - Sheetfed Scanner Operator's Manual page 69

Symptom
Multi feed* frequently
occurs.
Paper is not fed (paper
feed error occurs fre-
quently, or document
stops midway).
The generated image
are elongated.
There is a shadow on
the leading edge of the
generated image.
* "Multi feed" means that more than 2 papers are fed at the same time.
Check this item
Does the document satisfy the "Doc-
ument Quality" described in Section
2.2.1?
Are the documents set properly in
the ADF paper chute?
Is the document stack thicker than
4mm?
Is the Pad ASSY dirty?
Is the Pad ASSY worn out?
Does the document satisfy the "Doc-
ument Quality" described in Section
2.2.1?
Is the thick document placed on the
Flatbed?
Is the Pick roller dirty?
Is the Pick roller worn out?
Is the Pick roller dirty?
Are the Pinch rollers dirty?
Have you adjusted the offset (the
scanning starting position)?
fi-5015C Image Scanner Operator's Guide
4.2 Troubleshooting
Remedy
Scan the documents by Flatbed.
Fan the documents before scanning.
Correctly align the document stack
and load them on the ADF paper
chute. Refer to Section 2.2.2 for
details.
Reduce the number of sheets in the
document stack to 4 mm thickness or
less.
Clean the Pad ASSY. Refer to the
Operator's Guide "3.2.3 Cleaning the
ADF".
Replace the Pad ASSY. Refer to the
Operator's Guide "3.3.3 Replacing the
Pad ASSY".
Scan the documents by Flatbed.
Remove the document from the Flat-
bed.
Clean the Pick roller. Refer to the
Operator's Guide "3.2.3 Cleaning the
ADF".
Replace the Pick roller ASSY. Refer
to the Operator's Guide "3.3.4
Replacing the Pick Roller".
Clean the Pick roller. Refer to the
Operator's Guide "3.2.3 Cleaning the
ADF".
Clean the Pinch rollers. Refer to the
Operator's Guide "3.2.3 Cleaning the
ADF" on page 39..
Adjust the [Sub-scan Setting] on
[Scanners and Cameras] in the control
panel.
4
55