Desa HRB3624 Owner's Operation And Installation Manual page 24

OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, pages 22 and 23.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11, Lighting Instructions, page 23.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
42). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 22.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Slide the selector switch to
the REMOTE position (see Figure 33). Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Control Knob in
On Position
Selector Toggle Switch (Optional
Hand-Held Remote Control)
Figure 33 - Setting the Selector switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 34).
24
Flame Adjustment
Knob
ON
OFF
REMOTE
www.desatech.com
TO LOCK press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 34 - On/Off Hand-Held Remote
Control Unit
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 35). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Digital Display Shows
Locks
Temperature and Settings
System to
Prevent
Accidental
Ignition
ROOM
TEMP
Turns
LOCK
Burners
On or
MANU
Off
Increases
or Decreases Room
Temperature in
AUTO Mode
Figure 35 - Thermostat Hand-Held
Remote Control Unit
Control
Button
Turns
Hand-Held
Remote On
AUTO
SET
TEMP
or Off and
Allows You
TEMP
to Choose
POWER
the Manual
Setting
AUTO
ºC/ºF
Selects
AUTO
Mode
°C/°F Mode
Button
119426-01A