GAS GAS EC 125 - 2003 Service Manual page 20

Oil level
- Stand the motorcycle upright and level allow a few minutes for the
oil to settle.
(A)
- The maximum and minimum lever of oil is this window.
- By another way, if the oil level is smaller, fill up opening the fill plug
(C). Use the same oil type than you had.
- Observe the oil level
at the window (A) on
the lower right side of
the engine case.
(B)
- If the lever is higher,
you have to empty the
leftover oil by the oil
drain plug (B).
Transmission oil type
Oil Change
- The transmission oil should be changed periodically to assure long
engine life.
- Warm the engine (over 5 minutes) to suspend the sediment, liquify
the impurities, and faciclitate removal.
- Stop the engine, and place an oil pan beneath the engine.
- Remove the drain plug and position the vehicle so that it is
perpendicular to the ground to allow all the oil to drain out.
- Install the drain plug with its gasket, tightening it to20-Nm.
- Remove the oil filler opening plug of fresh transmission oil (C).
EC 200/ 250/ 300 remove with 900 cc and EC 125 with 650 cc.
- Check the oil level, after kicking the kick pedal 3 or 4 times.
- Install the oil filler opening plug.
82
EC 2003 - -
Viscosity: SAE 10W30.
Capacity: 1000 cc.
200/250/300 cc.
(C)
(C)
125 cc.