Daikin CCXS18PVM Service Manual Removal Procedure

Daikin CCXS18PVM Service Manual Removal Procedure

Indoor unit 9000/12000/18000 btu/h

Advertisement

Si091659E
REMOVAL
PROCEDURE
S E R V I C E
M A N U A L
9000/12000/18000 Btu/h
Indoor Unit
Inverter
Ceiling Mounted Cassette
Type (Single Flow)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CCXS18PVM and is the answer not in the manual?

Questions and answers

Summarization of Contents

Air Filters and Front Grille Removal
Air Filter Removal Procedure
Steps for safely removing the unit's air filters, including the photocatalytic type.
Front Grille Detachment
Procedure for releasing and removing the front grille assembly.
Horizontal Blades Removal
Blade Shaft Release Mechanism
Instructions for releasing horizontal blades from their central, left, and right shafts.
Decoration Panel Assembly Removal
Service Cover and Harness Disconnection
Steps to remove the service cover and disconnect internal harnesses.
Decoration Cover Detachment
Procedure for releasing the decoration cover via hooks.
Display and Control Panel Extraction
Steps to unfasten and remove the display and control panel.
Decoration Panel Fastener Release
Detaching the decoration panel by loosening screws on its sides and center.
Air Outlet Assembly and Swing Motors
Air Outlet Assembly Extraction
Procedure for removing the main air outlet assembly from the unit.
Horizontal Blade Swing Motor Release
Steps to detach and remove the swing motor for horizontal blades.
Vertical Blade Swing Motor Release
Procedure for removing the swing motor used for vertical blades.
PCBs and Thermistor Removal
Signal Receiver Unit and PCB Extraction
Steps to disconnect and remove the signal receiver unit and its associated PCB.
Room Temperature Thermistor Extraction
Procedure for removing the room temperature thermistor assembly.
Electrical Box Components Removal
Electrical Box Connector Disconnection
Disconnecting power wires, connectors, and relay connectors from the electrical box.
Left Shield Plate Detachment
Steps to remove the left shield plate by unfastening screws and hooks.
Main and Service PCB Extraction
Procedures for disconnecting and removing the main and service PCBs.
Drain Pan and Antibacterial Agent
Drain Plug and Residual Water Drainage
Procedure for removing the drain plug and draining any remaining water.
Drain Pan Detachment
Steps to unscrew and remove the main drain pan.
Antibacterial Agent Handling
Locating and managing the antibacterial agent within the drain pan.
Drain Pump Assembly Removal
Right Drip Proof Plate Removal
Procedure for removing the right-side drip proof plate.
Ground Wire and Thermistor Extraction
Steps to remove the earth/ground wire and heat exchanger thermistor.
Drain Pump Unit Detachment
Procedure for detaching and removing the drain pump assembly unit.
Heat Exchanger Unit Removal
Fixing Plate Detachment
Steps to remove the fixing plate securing the heat exchanger.
Left Drip Proof Plate Extraction
Procedure for detaching and removing the left drip proof plate.
Heat Exchanger Main Body Removal
Steps to remove the main heat exchanger unit from the casing.
Fan Motor and Rotor Removal
Fan Rotor and Cover Extraction
Procedure for removing the fan rotor and its protective cover.
Fan Motor Unit Detachment
Steps to detach and remove the fan motor unit.

Table of Contents