HP J9728A Multicast And Routing Manual

HP J9728A Multicast And Routing Manual

For wb.15.16
Table of Contents

Advertisement

HP Switch Software
Multicast and Routing Guide for WB.15.16
Abstract
This switch software guide is intended for network administrators and support personnel, and applies to the switch models
listed on this page unless otherwise noted. This guide does not provide information about upgrading or replacing switch
hardware. The information in this guide is subject to change without notice.
Applicable Products
HP Switch 2920-series:
J9726A
J9727A
J9728A
J9729A
HP Part Number: 5998-6867
Published: October 2014
Edition: 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the J9728A and is the answer not in the manual?

Questions and answers

Summarization of Contents

1 Multimedia Traffic Control with IP Multicast (IGMP)
Overview
Describes multimedia traffic control with IP multicast and IGMP.
IGMP general operation and features
Explains how IGMP reduces bandwidth usage and its applications.
Configuring and displaying IGMP (CLI)
How to configure and view IGMP settings using the command-line interface.
How IGMP operates
Explains IGMP message types and operation.
IGMP proxy forwarding
Propagates IGMP joins across router boundaries.
Using the switch as querier
Explains the IGMP Querier function and its role.
2 Multimedia Traffic Control with IP Multicast (IGMP) v2 NG
IGMP V2 NG Overview
Introduces IGMP v2 NG, its architecture and features.
Features overview
Lists existing and new features in IGMP v2 NG.
Configuring Per-Port IGMP Traffic Filters
Specifies how each port handles IGMP traffic.
Configuring the Querier Function
Enables or disables the switch's ability to act as an IGMP querier.
3 IP Routing Features
Overview
Lists the IP routing features offered by the switch.
IP interfaces
How IP addresses are associated with VLANs and subnets.
IP route table
Contains routing paths to IP destinations.
Configuring static IP routes
Creates static routes by adding them to the route table.
Configuring RIP
Describes how to configure RIP using the CLI.
Configuring DHCP relay
Explains DHCP for configuring hosts with IP addresses.
UDP broadcast forwarding
Configures forwarding of UDP broadcast packets.

Table of Contents

Save PDF