Martin Audio C516 User Manual page 5

<
CONTENTS
5. Put the support bracket through the ceiling cut-out and stand it up on
the ceiling rear surface. If support rails are used, place the feet over
the rails (see Fig. 2).
Fig. 2
6. Push the back-can up through the cut-out and locate the hole in the rear
of the back-can on the stud at the centre of the support bracket
(see Fig. 3).
7. Tighten the wing nut on the stud. This will sandwich the ceiling between
the support bracket and the front lip of the can.
>
PRINT
Martin Audio – C516 Ceiling Loudspeaker
ø212mm
Fig. 3
5
GUIDES