Remington 496 Operating Instructions Manual page 22

E. ATTACHING REAR PAD AND HANDLE PAD ASSEMBLY
1. Replace the handle pad assembly. Tighten screw with 3mm Allen wrench.
2. Replace the rear pad with two screws provided. The screws will also secure the
outer liner replaced in step A. Inserting Outer Liner Assembly into Housing (see
Figure 16).
Outer Liner
Assembly
Figure 16 - Replacing Handle Pad Assembly and Rear Pad
F. ASSEMBLING BARREL ASSEMBLY
1. Insert piston assembly into barrel (see Figure 17).
2. Insert buffer in muzzle cap.
3. Screw muzzle cap to barrel assembly.
4. Insert barrel into outer liner assembly (see Figure 18).
Buffer
Muzzle Cap
Figure 18 - Inserting Barrel Assembly into Outer Liner Assembly
Piston
Figure 17 - Inserting Piston in Barrel
Barrel
Piston
Handle Pad Assembly
Outer Liner Assembly
22
Rear Pad
Screws
3mm Allen Wrench
Barrel
105635