Specifications - Arcam FMJ T32 - AUTRE Handbook

specifications

FM section
Tuning range
Frequency steps
Sensitivity (IHF)
Signal to noise ratio
THD+n
AM section
Tuning range
Usable sensitivity
IF rejection
S/N ratio (30% mod., 5mV input)
Total harmonic distortion (30% mod., 5mV input)
Output level
DAB section (where fitted)
Tuning range:
Sensitivity (VHF measurement to EN50248)
Audio data rate (maximum)
Sirius section (where fitted)
Specifications are determined by SiriusConnect module
Control inputs
IR remote standard
IR in signal level
87.5 to 108.0MHz
50kHz
typically 4µV
65dB at full modulation, 1kHz
0.3% at full modulation, 1kHz
530 to 1710 kHz; 10kHz step
531 to 1602 kHz; 9kHz step
typically 20µV
> 32dB
> 42dB
< 1.5%
270mV at 30% modulation
174–240MHz (Band III)
1452–1492MHz (L band)
better than -91dBm, typically -97dBm
224kbits/s at MPEG protection level 3
Philips RC-5, 36kHz carrier
4–15V pk-pk
General
Supply voltage
Power consumption
Presets
Size
Weight
Supplied accessories
E&OE
NOTE: All specification values are typical unless otherwise stated
e-16
110–120V or 220–240V, set by rear panel voltage
selector switch
15W maximum; standby power 1W
100 presets, with14 presets accessible from front panel
preset buttons
W430 x D290 x H85mm
nett: 5.3kg/packed: 6.8kg
FM dipole aerial
DAB dipole aerial (DAB version only)
AM loop aerial
mains lead
CR90 remote control handset
4 x AAA batteries
continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.