Central Pneumatic 92917 Set Up And Operating Instructions Manual page 13

FEEd
NAILS
PAWL
(51)
CANISTER (90)
3. Place a coil of Nails (99) around the
Canister Platform (86) in the Nail
Canister (90).
4. Uncoil enough nails to reach the
Feed Pawl (51). Place the second
nail on the coil between the teeth
of the Feed Pawl, making sure the
nail head fits in the slot in the upper
portion of the Feed Pawl.
5. Swing the Canister Cover (84)
closed. Then, close the Door (53).
Make sure the Door closes securely.
If it does not engage, the nail head is
not in the slot in the upper portion of
the Feed Pawl (51).
Shingle Gauge Adjustment
BOTTOm VIEW
SHINGLE SPACING
1. The Bracket (96) controls roof
shingle spacing. To adjust the
Bracket to work with a particular
SKU 92917 For technical questions, please call 1-800-444-3353.
93253
CANISTER
COVER (84)
CANISTER
PLATFORm (86)
(TuRN TO AdjuST)
BRACkET
(96)
SCREWS
(28)
width of shingles, use the accessory
Hex Wrench (97) to loosen the two
Screws (28) on the Bracket.
2. Slide the Bracket forward or
backward to the desired spacing.
3. Then, retighten the two Screws.
General Operating Instructions
1. Test the Tool, as directed in the prior
section, before each use.
2. If an automatic oiler is not used,
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
3. Attach the Nailer to the air supply at
the air inlet. Start your compressor
and check the pressure making sure
it is set at the recommended 70-100
PSI and not to go over the maximum
100 PSI.
SAFETY
NOSEPIECE
ROOFING
SHINGLE
4. To fire, place the nose of the Nailer
on the workpiece. The Nailer should
not fire if the nose is not depressed.
Once depressed, gently and briefly
squeeze the Trigger (73) once. do
not fire repeatedly. Nails could
bounce off of one another, damaging
the workpiece or causing PERSONAL
INJURY.
add
AIR SuPPLY
HOSE
(NOT INCLudEd)
TRIGGER
(73)
Page 13