Related Manuals for Tempur-Pedic Twin
Summary of Contents for Tempur-Pedic Twin
- Page 1 ® COMPLETE REFERENCE GUIDE U.S. Patent No. 7,321,811 and other patents pending TPNA-CRG-TAES-0509 © 2009 Tempur-Pedic Management, Inc. 1713 Jaggie Fox Way, Lexington, KY 40511. All Rights Reserved.
-
Page 2: Table Of Contents
The decision to repair or to replace defective parts under this warranty shall be made, or case to be made, by Tempur-Pedic at its option and in its sole TROUBLESHOOTING ....................18 discretion. - Page 3 Safety Precautions ® SAFETY PRECAUTIONS GROUNDING SAFETY WARRANTY PRECAUTION! This product is for use on a nominal 120-volt circuit, and Do not open control box, motors or wireless remote has a grounding plug that looks like the plug illustrated control (with the exception of the battery compartments). in sketch A (see Figure).
-
Page 4: Safety Precautions
Safety Precautions ® IMPORTANT SAFETY FEATURES The input transformer voltage is AC120V (1 Amp) 60HZ, RADIO FREQUENCY IS 433.92 MHZ. INTENDED USAGE Use this furnishing only for its intended use as described and the output voltage is DC24V (3 Amp). When there is The electric adjustable bed should be installed with FCC COMPLIANCE in these instructions. -
Page 5: Commonly Asked Questions And Answers
WHAT IS THE LIFT CAPACITY OF THE ERGO SYSTEM? casters installed, is approximately 7 5/8”. See chart on 39 3/8” Please see the chart below for Tempur-Pedic’s page 9 for other options. recommended and approved “total people weight” limits WHY CAN’T I READJUST THE ERGO SYSTEM BASE per the available mattress and Ergo Base combinations. -
Page 6: Installation
Installation ® Installation Instructions STEP 1 STEP 3 Carefully lift your Ergo System out of the shipping Remove and extend the power cord from the frame. carton, keeping the unit top side down. For safety reasons, this should be performed by 2 people. STEP 2 Attach Ergo System Legs: Open the accessories box, take out the 6 legs, and... - Page 7 NOTE: If the Ergo System is to be set up without between (D) and (E). STEP 1B a headboard, simply place your Tempur-Pedic Place the Inner Headboard Bracket (D) into the mattress onto the frame. Installation is now C-channel frame, making sure the bracket opening and complete.
-
Page 8: Operation
If a new STEP 3 signal is not received, it will reset itself to normal Place your Tempur-Pedic mattress on top of your Ergo Repeat on the other side. mode in 10 seconds. -
Page 9: Wireless Remote Control Features
Operation ® Wireless Remote Control Features Operating Instructions READ ADVISORY INFORMATION IN THE SAFETY PRECAUTIONS SECTION OF THIS GUIDE CAREFULLY BEFORE HEAD AND FOOT ADJUSTMENTS (A, B) MASSAGE STOP (G) USING THIS PRODUCT. THE POTENTIAL FOR ELECTRIC SHOCK EXISTS IF ELECTRICAL COMPONENTS ARE NOT INSTALLED OR OPERATED PROPERLY. -
Page 10: Troubleshooting
Troubleshooting ® Troubleshooting SYMPTOM SOLUTION with four (4) new AAA batteries if necessary. In the event that your TEMPUR Advanced Ergo System fails to operate properly, investigate the symptoms and possible ® ™ solutions provided in the chart below: of the motors (do not operate more than two (2) minutes over a eighteen (18) minute period, or SYMPTOM SOLUTION... - Page 11 NOTE: Lowering using this method is much slower than the standard process. FOR TECHNICAL SUPPORT OR SERVICE, PLEASE CHOOSE FROM THE FOLLOWING NUMBERS: QUESTIONS ABOUT YOUR ERGO SYSTEM BASE: 1-800-979-1457 QUESTIONS ABOUT YOUR TEMPUR-PEDIC MATTRESS OR TO ORDER ERGO SYSTEM ACCESSORIES: 1-800-821-6621 OR VISIT WWW.TEMPURPEDIC.COM...
Need help?
Do you have a question about the Twin and is the answer not in the manual?
Questions and answers