Suburban DYNALINE DL3-0912 Owner’s Manual Installation, Operating And Service Instructions

Packaged terminal air conditioner

Advertisement

PACKAGED TERMINAL AIR CONDITIONER
MODELS: DL3-0712 • DL3-0912 • DL3-1220 • DL3-1622
INSTALLATION, OPERATING AND SERVICE INSTRUCTIONS
This book contains instructions for installation and operation of your unit. Keep it in a safe place for ready reference.
WARNING!
If the information in these instructions are
not followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach a gas supplier, call the fire
department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING!
Improper installation, adjustment, alteration,
service or maintenance can cause property damage, personal
injury or loss of life. Refer to the installation instructions and/
or owners manual provided with this appliance. Installation
and service must be performed by a qualified installer, service
agency or the gas supplier.
FOREWORD
You have just purchased a Suburban Packaged Terminal Air Conditioner. Models
0712, 0912, 1220 AND 1622 are certified by the Canadian Standard Association
under Z21.86-2008/CSA 2.32-2008 UL484.
To simplify the proper installation and to assure that the unit will operate in
conformity with generally accepted safety regulations, it requires that you read
carefully and fully understand the step-by-step instructions outlined in this manual.
CAUTION: Due to the differences in vinyl siding, this appliance should not
be installed on vinyl siding without first consulting with the manufacturer
of the siding or cutting the siding away from the area around the appliance
vent.
NOTE: Do not deviate from the instructions as outlined in this manual. Failure
to follow the installation, operating and maintenance instructions will void the
responsibility of Suburban Manufacturing Company.
Part Number 81758
10-31-2017
DYNALINE
OWNER'S MANUAL
Should you require further information, contact your dealer.
Your unit was carefully packed in a container which complies with the National
Safe Transit Test. This means that the packaged product, with normal handling,
will withstand the load conditions encountered in normal transit and in handling.
Your unit should be inspected immediately after unpacking to determine if any
damage is present due to shipping or handling. If any damage is discovered, do
not install the unit. Notify the transportation company immediately and file a
damage claim.
The manufacturer can bear no responsibility for damages which occur in transit or
for improper operation of the unit as a result of shipping damages.
For future reference, you should record the following information from the units.
MODEL NUMBER _______________________________________________
SERIAL NUMBER ______________________________________________
STOCK NUMBER _______________________________________________
DATE OF PURCHASE ___________________________________________
Do not operate the unit during construction period; this
may be a breach of the warranty conditions.
BTU INPUT
VOLTS
AMPS
GAS
CONNECTION
COOLING
CAPACITY
VOLTS
WATTS
REFRIGERANT
CHARGE
REFRIGERANT
1
SUBURBAN APPLIED PRODUCTS
www.SuburbanHVACproducts.com
INSPECTING FOR FREIGHT DAMAGES

UNIT SPECIFICATIONS

HEATING
DL3-0712
DL3-0912
12,000
12,000
208/230
208/230
2.0
2.0
3/8" IPS
3/8" IPS
COOLING
DL3-0712
DL3-0912
7600/7800
9300/9500
208/230
208/230
675/705
830/855
SEE INFORMATION STICKER ON UNIT
Suburban DynaLine Owner's Manual 10/2017 Rev.1
AIRXCEL, INC.
156 Seedling Drive
Cordele, GA 31015
(229) 273-3636
MODEL
DL3-1220
DL3-1622
18,000
20,000
208/230
208/230
2.0
2.0
3/8" IPS
3/8" IPS
MODEL
DL3-1220
DL3-1622
11500/11700
15000
208/230
208/230
1075/1125
1520/1580
R410A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DYNALINE DL3-0912 and is the answer not in the manual?

Questions and answers

Summarization of Contents

DYNALINE™ PACKAGED TERMINAL AIR CONDITIONER
OWNER'S MANUAL INSTALLATION, OPERATING AND SERVICE INSTRUCTIONS
Guide for installing, operating, and servicing the Dynaline unit.
IMPORTANT SAFETY WARNINGS AND GAS LEAK PROCEDURES
Crucial safety instructions for gas leaks and general warnings.
UNIT SPECIFICATIONS
Technical details including heating and cooling capacities, voltage, and gas connection.
PRE-INSTALLATION TIPS AND CONSIDERATIONS
MINIMUM OPERATIONAL CLEARANCES
Specifies required clearances around the unit for safe operation and servicing.
INSIDE CLEARANCES AND COMBUSTIBLE CONSTRUCTION
Details inside clearances and requirements near combustible materials.
INSTALLATION PROCEDURES
WALL SLEEVE AND FRAMING INSTALLATION
Step-by-step guide for installing the wall sleeve into the opening.
GAS AND ELECTRICAL CONNECTION GUIDELINES
Instructions for making gas and electrical hookups.
EMERGENCY POWER CONNECTION DETAILS
Details on connecting 24 VAC for compressor lock-out.
HEAT MODE INITIAL LIGHTING AND OPERATION
Initial lighting and operation steps for the heating mode.
OPERATING MODES AND CO DETECTOR FUNCTIONS
NORMAL OPERATION SEQUENCES (HEAT AND COOL MODES)
Step-by-step guides for normal heating and cooling operation.
CARBON MONOXIDE DETECTOR OPERATION AND TESTING
Details on CO detector modes, testing, alarms, and response.
UNIT CONTROLS, SERVICE AND MAINTENANCE
CO DETECTOR LIMITATIONS AND OPERATING TIPS
Discusses CO detector limitations, operating tips, and system controls.
PREVENTIVE MAINTENANCE CHECKLIST AND SERVICE
Comprehensive list of inspection points for annual maintenance and service procedures.
OWNER INSPECTION, FILTER AND COIL MAINTENANCE
PERIODIC CHECKS FOR BURNER, VENT, AND AIRFLOW
Visual checks for burner flame, vent obstructions, and air flow.
FILTER REMOVAL/CLEANING AND CONDENSER COIL CLEANING
Procedures for filter maintenance and condenser coil cleaning.
UNIT AND WALL SLEEVE DIMENSIONS
UNIT OVERALL DIMENSIONS
Provides the main physical dimensions of the Dynaline unit.
WALL SLEEVE FRAMING FOR REAR GAS HOOK-UP
Illustrates framing dimensions for the wall sleeve with rear gas connection.
WALL SLEEVE INSTALLATION DETAILS
FRAMING FOR FRONT GAS HOOKUP
Shows framing dimensions for the wall sleeve with front gas connection.
REAR GAS HOOKUP WALL INSTALLATION AND MEASUREMENTS
Details wall sleeve projection, slope, and sealing for rear gas hook-up.
FRONT GAS HOOKUP AND LEVELING INSTALLATION
FRONT GAS HOOKUP AND DRAINAGE SYSTEM
Details wall installation for front gas hookup, including drain tube assembly.
LEVELING LEGS INSTALLATION PROCEDURE
Instructions for installing and adjusting the leveling legs.
SPECIAL INSTALLATION TYPES AND CONTROL INTERFACE
INSTALLATION IN VARIOUS WALL TYPES
Guidance for installing in windows, curtain walls, or panels.
CONTROL PANEL AND THERMOSTAT CONNECTIONS
Details on display panel, thermostat switch, and remote thermostat connections.
ELECTRICAL SCHEMATICS
WIRING DIAGRAMS WITHOUT CO DETECTOR
Electrical schematics for units without a carbon monoxide detector.
WIRING DIAGRAMS WITH CO DETECTOR
Electrical schematics for units equipped with a carbon monoxide detector.
OPERATIONAL AND MAINTENANCE ILLUSTRATIONS
WIRING DIAGRAM WITH CO DETECTOR
Detailed wiring diagram for units with a CO detector.
BURNER FLAME AND COIL CLEANING VISUALS
Visual guide for correct burner flame and condenser coil cleaning.
VENTILATION CLEARANCES AND INSTALLATION CODES
CLEARANCES FOR VENT TERMINALS AND AIR INLETS
Specifies clearances for vent terminals and air supply inlets per codes.
CLEARANCES FROM BUILDING FEATURES AND SIDEWALKS
Details clearances relative to windows, doors, soffits, corners, and sidewalks.
OPTIONAL ACCESSORIES
ALUMINUM GRILLE INSTALLATION
Information on installing the standard aluminum grille.
ARCHITECTURAL STYLE GRILLES INSTALLATION
Details on installing optional architectural grilles.
OPTIONAL AIR DISCHARGE PACKAGE
AIR DISCHARGE PACKAGE COMPONENTS AND INSTALLATION
Instructions for installing the optional air discharge package.
OPTIONAL CARBON MONOXIDE DETECTOR
Illustration and reference to the optional CO detector.
MASSACHUSETTS INSTALLATION REQUIREMENTS
MANDATORY CARBON MONOXIDE DETECTOR INSTALLATION
Requirements for CO detector installation in Massachusetts.
SIGNAGE, INSPECTION, AND EXEMPTIONS
Mandates for signage, inspection, and applicable exemptions.
SUBURBAN LIMITED WARRANTY
LIMITED WARRANTY COVERAGE AND DURATION
Details one-year and four-year limited warranties for parts and labor.
WARRANTY EXCLUSIONS AND PRODUCT SUPPORT CONTACTS
Lists exclusions and provides contact info for product issues.

Table of Contents

Save PDF