HP Mp3130 - Digital Projector XGA DLP User Manual page 64

Fixing Problems
If the projected colors seem completely wrong:
If the picture settings are completely wrong and you cannot fix them:
If a DVI device causes an error message or garbage on the screen:
If the projector stops responding to all controls:
64
❏
Open the on-screen menu and select Adjust picture > Color
space. Change the selection.
❏
Open the on-screen menu and select Help > Diagnostics. Run
color tests.
❏
For a YPbPr or RGB input device, be sure all the video
connectors are correctly matched.
❏
Be sure the pins on the cable connectors are not bent or broken.
❏
Open the on-screen menu and select Adjust picture > Color
space. Change the selection.
❏
Open the on-screen menu and select Help > Diagnostics. Run
color tests.
❏
Reset the picture settings to the factory-default settings. See the
following problem.
❏
Reset the projection settings to the factory-default settings. To do
this, hold down the down
projector for 5 seconds. (This does not reset attachment module
settings.)
❏
Certain high-definition digital sources incorporate
High-bandwidth Digital-Content Protection (HDCP) content
protection. Such content cannot be displayed by this projector. If
the device has another output port, such as S-video, try
connecting that port to the projector.
❏
If possible, turn off the projector, then unplug the power cord and
wait at least 15 seconds before reconnecting power.
+ up + right buttons on the
User's Guide