Xtant 2140C Specifications

2 1 4 0 c f e a t u r e s
D I S C O N T I N U E D D E C E m B E R 1 9 9 7
• Fully regulated, PWM power supply.
• Doubling of power from 4 to 2
• Hand-matched, complementary MOSFETS
for better performance and sound quality.
• Fully discrete power amp.
• Independent amplifier channel gain adjust-
ment.
• Forced air convection cooling.
• Over-current and thermal protection circuitry.
• Input sensitivity (100 mV to 8 V RMS)
adjustable in 10 dB steps.
• Balanced line input ports – designed to
accept our (optional) BLM 1 module.
3 o v.2.00
Watts Per Channel @ 4
Watts Per Channel @ 2
Watts Per Channel @ 4
Frequency Response:
Distortion (THD):
Signal to Noise Ratio:
Damping Factor:
Input Sensitivity (unbalanced source):
Input Sensitivity (balanced source):
Input to Line Output Gain:
Operational Voltage:
On-Board Crossover:
Module Port(s):
Power Supply:
Fusing:
• One accessory port – designed to accept our
(optional) accessory modules.
loads.
• Built-in noise gate with threshold adjust-
ment control.
• 13 frequencies available for each amplifier.
• RCA line level outputs controlled by on-
board crossovers.
• On-board crossover has 3 modes of opera-
tion – high pass, low pass, or bypass.
• Amp may be run in "Mixed Mono" mode
using passive crossovers.
• 4 year parts and labor warranty when
installed by an authorized Xtant dealer.
2140c specifications
2 x 70
2 x 140
Bridged 1 x 280
5 Hz to 50 kHz +/– 1 dB
< .04%
> 100 dB
> 200 @ 100 Hz with 4 load
100 mV to 8.5 V RMS
100 mV to 17 V RMS
0 dB +/– 20 dB, 10 dB steps
11 to 15 Volts
12 dB per Octave "Butterworth"
1 – Accessory Port
1 – Balanced Line Port
Fully Regulated, PWM
50 Amp