Selecting The Operating Mode - IBP DIGITAL TENS Instructions For Use Manual

46
4. Setting the times:
• Setting the cycle switch-on time:
Press the SET button until the ON display for the cycle switch-on
time lights up and flashes.
• Press the RATE button ▲ or ▼ until the display shows the
required cycle switch-on time.
You can set the cycle switch-on time for anything from 1 to 30
seconds.
Each time the button is pressed, the display jumps in 1 sec intervals
to the next possible higher or lower adjustment.
• Setting the build-up period (ramp):
Press the SET button until the RAMP display for the build-up period
lights up and flashes.
• Press the RATE button ▲ or ▼ until the display shows the
required build-up time
You can set the build-up time for anything from 1 to 8 seconds.
Each time the button is pressed, the display jumps in 1 sec intervals
to the next possible higher or lower adjustment.
• Setting the cycle switch-off time:
Press the SET button until the OFF display for the cycle switch-on
time lights up and flashes.
• Press the RATE button ▲ or ▼ until the display shows the
required cycle switch-off time.
You can set the cycle switch-off time for anything from 1 to 30 seconds.
Each time the button is pressed, the display jumps in 1 sec intervals
to the next possible higher or lower adjustment.
• Saving all the time settings:
Press the ENT button briefly. This saves your settings.

10.3 Selecting the operating mode

We recommend that all your treatment parameters, including pulse frequency,
pulse width and pulse strength, are individually checked and set by a doctor or
therapist.
For the treatment to work successfully it is necessary for the patient to
experience a noticeable tingling feeling or vibration on the skin. If the success
of the treatment begins to wane after a time because the body accustoms itself
to the current settings, a doctor or therapist can re-check and re-set the
treatment parameters. In such a case it may be sensible also to change the
operating mode, i.e. select a modulated operating mode.
If a doctor or therapist is giving the treatment, s/he can monitor the
treatment continually and if necessary reset the parameters.
1. Switch on the Digital TENS.
2. Press the MODE button until the symbol for the required operating mode
flashes on the display.
You can select from five TENS and two EMS operating modes.
Each time you press the button the display will jump to the symbol
for the next operating mode.