Table of Contents
Advertisement
Installing Internet Guard Dog™
Installing Internet Guard Dog
After closing all open programs, you are ready to install Internet Guard Dog
on your PC. Installation should go smoothly, however, if you do have
difficulties, see
To install Internet Guard Dog
1. Close all open programs.
2. Insert the Internet Guard Dog CD in the CD-ROM drive.
3. In the Internet Guard Dog Setup screen, click Install Internet Guard Dog.
4. After installation is completed, Internet Guard Dog's Interview feature is
Troubleshooting installation problems
A failed installation can cause software problems that are difficult to track
down. The major causes of installation failure are:
• Hard drive errors
• Temporary files that conflict with the installation
• Attempting to install while other software is running
Follow the procedure outlined below to minimize the affect that these
common conditions may have on your installation.
12
Internet Guard Dog
"Troubleshooting installation problems" on page
NOTE: If the setup screen doesn't start automatically when you
close your CD-ROM drive, click Start on the Windows taskbar, click
Run, then type d:\setup. If D is not the drive letter of your CD-ROM
drive, substitute the correct drive letter.
launched. Follow through the screen instructions and provide
information as needed.
NOTE: Only the Administrator can access this Interview feature of
Internet Guard Dog. For more information, see
Guard Dog Interview" on page
"Using the Internet
15.
12.
Advertisement
Table of Contents
