McAfee DR SOLOMON S ANTI-VIRUS 8.5 User Manual page 163

3. Enter a password to use to lock your settings. Type any combination of
up to 20 characters in the upper text box in the Password area, then enter
the exact same combination in the text box below to confirm your choice.
æ IMPORTANT: The password protection in the WinGuard scanner
is different from the password protection you can assign to tasks in
the Dr Solomon's Anti-Virus Console or to settings in the Dr
Solomon's Anti-Virus application. Choosing a password for one
component does not assign that password to the other
component—you must choose passwords for each independently.
4. Click any of the other Security module tabs to protect individual
property pages. To save your password without closing the Security
Properties dialog box, click Apply. If you chose to protect all property
pages in all modules and want to close the dialog box, click OK. To close
the dialog box without saving any changes, click Cancel.
NOTE: Clicking Cancel will not undo any changes you already
saved by clicking Apply.
Entering your password to configure settings
Once you have protected your settings with a password, the Security module
will ask you to enter that password whenever you open the WinGuard
Properties dialog box
Figure 4-40. Verify Password dialog box
Enter the password you chose in the text box provided, then click OK to get
access to the WinGuard Properties dialog box.
(Figure 4-40).
Using the WinGuard Scanner
User's Guide 163