Connecting The Antenna Terminals - Denon DRA-CX3 Owner's Manual

NOTE
• Use speakers with an impedance of 4 to 16 Ω/ohms.
• When making connections, take care that none of the strands in the speaker cable come in contact with
adjacent terminals, other speaker cable strands, or with the rear panel and screws.
NEVER touch the speaker terminals when the power is on. Doing so can result in electric shocks.
Protection circuit
When using speakers with an impedance below the designated value (for example 3 Ω/ohms), playing
for long periods of time with the volume high can cause the temperature to rise, activating the protection
circuit.
When this circuit is activated, the output to the speakers is cut off and the power indicator blinks. If this
happens, unplug the power cord, wait for the set to cool off and improve ventilation around the unit. Also
check the wiring of the input cables and the speaker cables. After doing this, plug the power cord back in
and turn the unit's power back on.
If the protection circuit is activated again even though there are no problems with the wiring or the
ventilation around the unit, switch off the power and contact a DENON service center.

Connecting the antenna terminals

An F-type FM antenna can be connected directly.
Direction of broadcasting station
FM outdoor antenna
FM antenna
(Supplied)
Black
75 Ω/ohms
coaxial cable
AM loop antenna
(Supplied)
White
AM outdoor antenna
Ground
AM loop antenna assembly
Remove the vinyl tie and take
out the connection line.
a. With the antenna on top of
any stable surface.
Mount
Connection of AM antennas
1. Push the 2. Insert the 3. Return the
lever. conductor. lever.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC
which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to the point of cable entry as practical.
ENGLISH
Connect to the AM
antenna terminals.
Bend in the reverse direction.
b. With the antenna attached
to a wall.
Installation hole Mount on wall, etc.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an AM outdoor antenna is used, do not
disconnect the AM loop antenna.
• It is not possible to receive AM broadcasts with
good quality if the AM loop antenna is near
something metallic.