Brother GT-541 Instruction Manual page 115

Error
Message
code
2022 EMPTY Cyan
2023 EMPTY Yellow
2030 WASTE INK FULL
2040 WPC Removed
2050 Temp Low: xxx °F
2051
Temp High: xxx °F
2062 -
OBSTACLE SENSED
2070
Push OK, Unload
2080 Sys Wrt Fault
2090 Not Initiated
2091 Fail: Head Temp
2092 Fail: Head Temp K
2093 Fail: Head Temp M
2094 Fail: Head Temp C
2095 Fail: Head Temp Y
Card Not Ready
2100
Push OK Button
2101 Not Enough Area
2102 Card Access Error
Meaning
The Cyan Ink Cartridge ran out of
ink.
The Yellow Ink Cartridge ran out of
ink.
The Waste Ink Cartridge is full.
The Wiper Cleaner Cassette is not
installed.
The ambient temperature is under
the operative temperature rage.
"xxx" shows the current
temperature.
The ambient temperature is over
operative temperature rage.
"xxx" is the current temperature.
(1) Platen didn't return to the home
position because Platen Motor
stepped out. Or (2) Platen Org
Sensor did not work while Platen
returned correctly.
GT-541 detected an obstacle on
the Platen (or the media) when
printing is started.
Defect in FLASH ROM Check
Sum on the SH side.
When updating the firmware, no
backup was made because of the
defect of the current firmware.
No individual information (the serial
number etc.) is recorded in
GT-541.
The Print Head temperature is
raised too high while printing.
The Compact Flash is not inserted.
The Compact Flash does not have
enough area for storing logs.
Failure in file reading / writing
GT-541
7. Troubleshooting
Solution
Replace to a new Cyan Cartridge.
Replace to a new Yellow Cartridge.
Replace to a new Waste Ink Cartridge.
Install the Wiper Cleaner Cassette.
Raise the room temperature.
Drop the room temperature.
**
Remove the obstacle, flat the platen surface
and then press OK Button.
**
**
Wait until the head(s) cool down. Or contact
Brother Customer Service Hot Line.
Push OK Button to escape menu and
re-enter Compact Flash. Or see " 7-1.
Solving Printer Problems".
Check the free space of the Compact Flash
with PC.
Insert a Compact Flash with free area
available.
Push OK Button to escape menu and
re-enter Compact Flash. Or see " 7-1.
Solving Printer Problems".
105