Dsp Surround Simulation - Denon AVR-786 Operating Instructions Manual

ENGLISH
Basic Operation
SURROUND MODE
SURROUND PARAMETER

DSP surround simulation

2 To operate the surround mode and the surround
parameters from the remote control unit
1
Select the surround mode for the input channel.
(Remote control unit)
The surround mode switches in the following order each
time the DSP SIMULATION button is pressed:
MONO MOVIE ROCK ARENA
MATRIX VIDEO GAME
2
SURROUND PARAMETER
Press the
enter the surround parameter setting mode.
The surround parameter switches in the following order
each time the SURROUND PARAMETER button is pressed for
the different surround modes.
TONE CONTROL
SURROUND
MODE
CH SELECT /
ENTER
SELECT
TONE DEFEAT
3
Press the
press the
various parameters.
4
Press the
parameter settings.
5
Press the
parameter mode.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
JAZZ CLUB
2 Operating the surround mode and the surround
button to parameters from the main unit's panel
1
Turn the
mode.
When turned clockwise:
DIRECT
MONO MOVIE
ROCK ARENA
SURROUND
PARAMETER
CURSOR
SURROUND PARAMETER
button, and
CURSOR D D H H
or button to select the
CURSOR F F G G
or button to adjust the
ENTER
button to finish the surround
SELECT
knob to select the surround
II
STEREO DOLBY PRO LOGIC x
5CH/7CH STEREO DTS NEO:6
JAZZ CLUB VIDEO GAME
VIRTUAL SURROUND MATRIX
27
ENGLISH
When turned counterclockwise:
DIRECT STEREO DOLBY PRO LOGIC
MONO MOVIE 5CH/7CH STEREO
ROCK ARENA JAZZ CLUB VIDEO GAME
VIRTUAL SURROUND MATRIX
To select the surround mode while adjusting the surround
parameters, tone defeat or tone control, press the
SURROUND MODE button, then operate the selector.
2
SURROUND PARAMETER
Press and hold in the
button to select the parameter you want to set.
The parameters which can be set differ for the different
surround modes are displayed. (Refer to "Surround modes
and parameters" ( page 56).)
3
Display the parameter you want to adjust, then
SELECT
turn the knob to set it.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small),
"medium", "med.l" (medium-large) and "large". "small"
recreates a small sound field, "large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
DIRECT.
Basic Operation
II
x
DTS NEO:6