Playing A Dvd With Surround Sound; Connecting Other Sources; Cable Indications - Denon AVR-786 Operating Instructions Manual

ENGLISH
Easy Setup and Operation
4 CURSOR D D H H
Press the or
the following three items based on the
measurement results, then press the
button.
Store:
Store the checked measurement values.
All parameters are stored.
Retry:
Perform the measurement again.
Measurement is repeated.
Cancel:
Cancel the checked measurement values.

Playing a DVD with surround sound

1 Disconnect the microphone from the unit.
2
Select the input source to be played.
3
Select the play (surround) mode.
4
Start DVD playback.
5 Adjust the volume.

Connecting Other Sources

button to select from
CURSOR F F

Cable indications

The hookup diagrams on the subsequent pages assume the use of the following optional connection cables (not supplied).
A
Analog terminal (Stereo)
(White)
(Red)
B
Analog terminal (Monaural, for subwoofer)
C
Digital terminal (Coaxial)
(Orange)
D
Digital terminal (Optical)
E
Speaker terminal
NOTE:
• Do not plug in the power supply cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Note that binding pin-plug cables together with power supply cords or placing them near a power transformer will result in hum
or other noise.
Audio cable
L L
R R
Pin-plug cable
Pin-plug cable
Coaxial cable (75 /ohm pin-plug cable)
Optical cable (Optical fiber cable)
Speaker cable
11
ENGLISH
Video cable
F
Video terminal
(Yellow)
Video cable (75 /ohm video pin-plug cable)
G
S-Video terminal
S-Video cable
H
Component video terminal
(Green)
(Blue)
(Red)
Component video cable
Signal direction
Audio signal
IN OUT OUT
Video signal
IN OUT OUT
(Y)
(P /C )
B B
(P /C )
R R
IN
IN