Table of Contents
Advertisement
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
O
'
M
peratOr
s
anual
Two Stage Snow Thrower — 524 WE, 524 SWE,
526 SWE, 528 SWE & 528 SW
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA
Form No. 769-06030
(June 30, 2010)
Advertisement
Table of Contents
Related Manuals for Cub Cadet 528 SW
Summarization of Contents
To The Owner
Record Product Information
Locate and record model plate information for technical support and service.
Customer Support
Contact Cub Cadet for assembly help, questions on controls, operation, or maintenance.
Important Safe Operation Practices
California Proposition 65 Warning
Warning regarding chemicals in engine exhaust and vehicle components known to cause cancer or birth defects.
Training and Preparation
Instructions for safe operation, including reading manuals, familiarizing controls, and preparing the area.
Safe Handling of Gasoline
Gasoline Safety Guidelines
Precautions for handling gasoline to avoid personal injury or property damage due to flammability.
Operation
Engaging Drive and Augers
Instructions on how to engage the drive control for movement and the auger control for snow throwing.
Clearing a Clogged Discharge Chute
Chute Clearing Procedure
Step-by-step guide to safely clear a clogged snow thrower chute using the clean-out tool.
Maintenance & Storage
Engine Modification & Emissions
Information on engine modification restrictions and notice regarding emissions compliance.
Spark Arrestor Warning
Warning about the use of spark arrestors on engines, especially in certain land conditions.
Safety Symbols
Symbol Descriptions
Depicts and describes safety symbols found on the snow thrower and in the manual.
Assembly & Set-Up
Carton Contents
Lists the items included in the snow thrower packaging.
Handle Assembly
Instructions for assembling the handle of the snow thrower.
Chute Assembly
Detailed steps for assembling the chute and its control mechanism.
Shear Pins Setup
Shear Pin Storage
Guidance on storing replacement shear pins included with the snow thrower.
Adjustments
Skid Shoes Adjustment
Instructions on how to adjust skid shoes based on surface conditions for optimal performance.
Tire Pressure Check
Guidance on checking and maintaining proper tire pressure for the snow thrower.
Auger and Chute Controls
Auger Control Adjustment
Steps to check and adjust the auger control cable for proper operation.
Chute Assembly Adjustment
Instructions for adjusting the chute assembly angle for snow discharge direction.
Controls and Features Overview
Shift Lever Operation
Explanation of the shift lever's function for ground speed and direction.
Auger and Chute Assembly Features
Description of the auger system and chute assembly functions.
Headlight Feature
Information on the location and automatic operation of the snow thrower's headlight.
Control Operation Details
Auger and Drive Controls
Details on operating the auger control and the drive control, including the clutch lock.
Chute Clean-Out Tool Use
Instructions for safely using the chute clean-out tool to remove snow and ice.
Steering Trigger Controls
Explanation of how to use the left and right steering trigger controls.
Chute Directional Control
2-Way Chute Control
How to operate the 2-Way Chute Directional Control to change snow discharge direction.
4-Way Chute Control
How to operate the 4-Way Chute Directional Control for direction and angle.
Snow Thrower Operation
Starting and Stopping Engine
Reference to the engine manual for starting and stopping procedures.
Engaging Drive and Augers
Steps to engage the drive for movement and the augers for throwing snow.
Replacing Shear Pins
Procedure for checking and replacing shear pins if augers strike an object.
Maintenance & Adjustments
Engine Maintenance
Refer to Engine Operator's Manual for engine maintenance.
Shave Plate and Skid Shoes
Checking and replacing wear components like shave plates and skid shoes.
Lubrication (Wheels & Auger Shaft)
Lubrication points for wheels and the auger shaft at least once per season.
Tire Pressure
Guidance on checking and maintaining proper tire pressure for safe operation.
Shaft Lubrication and Adjustments
Gear Shaft Lubrication
Procedure for lubricating the gear (hex) shaft on a seasonal or hourly basis.
Shift Cable Adjustment
Instructions to adjust the shift cable if the full range of speeds is not achievable.
Auger Control Adjustment
Refer to Assembly section for auger control cable adjustment instructions.
Skid Shoes Adjustment
Refer to Assembly section for skid shoes adjustment instructions.
Drive Control and Storage
Drive Control Adjustment
Procedure to check and adjust the drive control cable for proper engagement.
Chute Control Rod Adjustment
Instructions for adjusting the chute control rod for proper rotation.
Off-Season Storage Guide
Steps for preparing and storing the snow thrower for extended periods.
Service - Belt Replacement
Auger Belt Replacement
Step-by-step guide to remove and replace the snow thrower's auger belt.
Service - Drive Belt
Drive Belt Replacement
Step-by-step guide to remove and replace the snow thrower's drive belt.
Service - Friction Wheel
Friction Wheel Inspection & Removal
Procedure for inspecting and replacing the friction wheel assembly or rubber.
Troubleshooting Common Issues
Engine Start Problems
Common causes and remedies for the engine failing to start.
Engine Performance Issues
Solutions for erratic engine running, overheating, and loss of power.
Drive and Discharge Problems
Troubleshooting for unit propulsion, snow discharge, and chute issues.
Chute Rotation Issues
Addresses problems with the chute not rotating easily 180 degrees.
Replacement Parts Guide
Belts and Pulleys
Part numbers for auger drive belts, wheel drive belts, and related components.
Wear Parts (Skid Shoes, Shave Plates)
Part numbers for wear items like skid shoes, shave plates, and friction wheel rubber.
Service Tools (Chute Tool, Spark Plug)
Part numbers for essential service tools including chute clean-out tool and spark plugs.
Attachments & Accessories
Available Attachments and Accessories
List of optional attachments and accessories for the snow thrower.
Manufacturer's Limited Warranty
Warranty Coverage Details
Details on warranty periods for non-commercial and commercial use against defects.
Obtaining Service and Exclusions
How to obtain warranty service and common exclusions from coverage.
Warranty Limitations and Legal Rights
Information on warranty limitations, implied warranties, and state-specific legal rights.
Need help?
Do you have a question about the 528 SW and is the answer not in the manual?
Questions and answers