Option Setup; Setting The Muting Level; Setting The On-Screen Display; Setting The Power Amp Assign - Denon AVR-1906 Operating Instructions Manual

Advanced Setup – Part 1

Option Setup

Setting the Muting Level

This sets the amount of attenuation applied for audio output
muting.
1 CURSOR D D H H
Press the or
"Option Setup" at the "System Setup" menu,
ENTER
then press the button.
• The "Option Setup" screen appears.
2 CURSOR D D H H
Press the or
"Muting Level" at the "Option Setup" menu,
ENTER
then press the button.
• The "Muting Level" screen appears.
3 CURSOR F F G G
Press the or button to select the
desired setting.
–20 dB:
Attenuation of the volume by –20 dB from the present level.
–40 dB:
Attenuation of the volume by –40 dB from the present level.
– – – dB:
The volume level is completely muted.
4
ENTER
Press the button to enter the setting.
• The "Option Setup" menu appears.
Setting the On-Screen Display (OSD)
• Use this to turn the on-screen display (messages other than the
menu screens) "ON" or "OFF".
• Sets the on-screen display mode.
button to select
1
Press the
Screen Display" at the "Option Setup" menu,
then press the
• The "On Screen Display" screen appears.
button to select
2
CURSOR F F
Press the
or "OFF".
3
Press the
on-screen display mode, then press the
F F G G
or
"MODE2".
MODE1:
Prevents flickering of the on-screen display when there is no
video signal.
MODE2:
Flickering is not prevented.
Use this mode if the on-screen display does not appear in
MODE1, which may happen depending on the TV being used.
4
Press the
• The "Option Setup" menu appears.
CURSOR D D H H
or button to select "On
ENTER
button.
G G
or button to select "ON"
CURSOR D D H H
or button to select the
CURSOR
button to select "MODE1" or
ENTER
button to enter the setting.
44
ENGLISH
Advanced Setup – Part 1

Setting the Power Amp Assign.

Make this setting to switch the power amplifier for the surround
back channel to ZONE2 or Bi-Amp.
SPEAKER OUT
Power Amp
Assign. MAIN ZONE ZONE2
Surround back 7.1ch system –
ZONE2 5.1ch system 2ch system
Bi-Amp 5.1ch system –
1
CURSOR D D H H
Press the or
"Power Amp Assign." at the "Option Setup"
ENTER
menu, then press the button.
• The "Power Amp Assign." screen appears.
2
CURSOR F F G G
Press the or button to select the
Amp Assign mode according to the speaker
system you want to set up.
3
ENTER
Press the button to enter the setting.
• The "Option Setup" menu appears.
ENGLISH
PRE-OUT
S.BACK/ZONE
Surround back
ZONE2
–
button to select