Potterton Kingfisher Mf 50 Installation & Service Instructions Manual
Potterton Kingfisher Mf 50 Installation & Service Instructions Manual

Potterton Kingfisher Mf 50 Installation & Service Instructions Manual

Advertisement

Installation & Service Instructions Kingfisher Mf 40 – 100
About the Boiler
See inside cover for models covered by these instructions.
This Floor Mounted Fan Assisted Gas Boiler is available as Conventional or Balanced Flue.
This boiler is for use with Natural Gas (G20) Only at 20mbar and for use in GB & IE.
About Safety
The Gas Safety (Installation and Use) Regulations 1994 (As Amended) & The Gas Safety
(Installation and Use) (Amendment) Regulations 1996.
'' In your own interest, and that of safety, it is law that all gas appliances are installed by
competent persons, in accordance with the above regulations. Failure to install appliances
correctly could lead to prosecution.''
Installation must be in accordance with the Installation & Service Instructions and the rules in
force.
Leave these instructions with the user for use on future calls.
Supplied By www.heating spares.co Tel. 0161 620 6677

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Kingfisher Mf 50 and is the answer not in the manual?

Questions and answers

Summarization of Contents

Installation & Service Instructions
About the Boiler
Describes the boiler's type, fuel, and intended use.
About Safety
Covers gas safety regulations and installation warnings for compliance.
Technical Data
Boiler Specifications
Provides detailed output, input, efficiency, and pressure data for models.
Installation Requirements
Gas and Electricity Supply
Details gas pipe sizing, electrical connections, earthing, and fuse requirements.
Boiler Location and Air Supply
Defines installation site, clearances, wall suitability, and ventilation needs.
Flue System Installation
Covers flue installation, lengths, terminals, and clearances for safe exhaust.
System and Pipework Requirements
Outlines system types, pipework, expansion vessels, and filling procedures.
Boiler Physical Installation
Step-by-step guide for mounting the boiler and connecting the flue.
Electrical and Water Connections
Details connecting water pipes and the power supply cable.
Optional Programmer Installation
Instructions for fitting and wiring an optional programmer.
Commissioning and User Guidance
Boiler Commissioning
Step-by-step process for initial boiler setup and checks.
Final Adjustments
Procedures for setting inlet and burner pressures and gas rate.
User Instruction and Advice
Guidance for the user on operation, frost protection, and servicing.
Service and Replacement of Parts
General Access and Safety Precautions
Steps to safely access internal components and precautions before work.
Component Servicing and Replacement
Procedures for servicing/replacing key components like sensors and switches.
Combustion System Components
Details on servicing the burner, gas valve, injector, and insulation.
Fan, Fluehood & Safety Devices
Procedures for servicing the fan, fluehood, and safety devices.
Wiring Diagrams and Fault Finding
Wiring Diagrams
Illustrates electrical connections for boiler components and controls.
Fault Finding Guide
Flowcharts and checks for diagnosing and resolving boiler faults.
Parts and Accessories
Short List of Spare Parts
Lists common replacement parts with catalogue numbers.
Optional Extras
Details available accessory kits for the boiler.

Table of Contents