Brother Internet Print Using Telnet To Configure The Print Server - Brother 2100P - NC Print Server User Manual

Brother Internet Print
Using TELNET to Configure the Print
Server
Skip this section if you used BRAdmin Professional utility or a Web Browser to
configure the remote print server.
As an alternative to BRAdmin Professional utility, you can use the print server
remote console to configure the print server. The console can be accessed via
TELNET. When you access the print server using these utilities, you will be asked
for a password. The default password is "access".
1. When you get the "Local>" prompt after connecting to the console, enter the
command:
SET POP3
where ipaddress is the IP address of your POP3 server (consult with your
network administrator if you do not know this address).
2. Enter the command:
SET POP3
SET POP3
where mailboxname is the name of the remote print server mailbox and
emailpassword is the password associated with this mailbox. Usually the
mailbox name is the same as the first part of the E-mail address that you
defined previously (for example, usually if the E-mail address is
emailprinter@xyz.com, then the mailbox name is emailprinter).
3. The print server is set by default to poll the POP3 server every 30 seconds.
If you wish to change this value, enter the command:
SET POP3
where rate is the polling rate in seconds.
Type EXIT to exit the console and save the changes. You have now
completed configuring the print server.
CHAPTER 5 BIP INTERNET PRINTING INSTALLATION
ADDRESS ipaddress
NAME mailboxname
PASSWORD emailpassword
POLLING rate
5-6