Advertisement
Available languages
Available languages
M5300 -EX Front Panel Features
Power Button
Power LEDs
Press and hold for 2 sec-
onds to turn Bank 2 and
Indicates the status of the rear panel
Bank 3 outlets ON or OFF.
outlets. LEDs for each outlet bank
This switch is bypassed if
will be lit when the outlets are turned
the rear panel DC Trigger
ON. They will flash during the start-
input is being used.
up and shutdown process.
M5300-EX
BANK 1
ALWAYS ON
POWER AND FILTRATION
M5300 -EX Back Panel Connection Features
Outlet Bank 2
Four switched outlets controlled by the
front panel Power Button or the DC Trigger
Circuit Breaker
input. Bank 2 will turn on immediately and
Automatically opens
turn off after 10 seconds. EMI/RFI noise fil-
when the current load
tration is provided by a three-stage balanced
is greater than 15
Pi filter which also provides noise isolation
Amps. Push to reset.
from Outlet Banks 1 and 3.
15 AMP CIRCUIT
BANK 3
BREAKER
GROUND
LUG
DELAY ON
MAIN POWER
HIGH CURRENT
120 VAC/15A
Main Power
Outlet Bank 3
Must be plugged
Two switched, high current
into a properly
outlets controlled by the
wired & ground-
front panel Power Button or
ed 3-wire outlet
the DC Trigger input. Bank 3
has a 5 second turn on delay
and turns off immediately.
The High Current outlets pro-
vide power from a low
Ground Lug
impedance noise filtration
Provides a common
circuit that does not limit the
grounding point for
current to your equipment.
equipment with sep-
Its output is noise isolated
arate ground leads.
from all other outlet banks.
Wiring OK LED
Normally On. Indicates
that the wall outlet is
properly grounded and
Line/Neutral polarity is
correct.
WIRING
BANK 2
BANK 3
OK
ON
ON
Outlet Bank 1
Four always on outlets. Power will only
be turned off under a fault condition.
(See specifications for over-voltage and
under-voltage thresholds)
cleaned by a three-stage balanced Pi fil-
ter which also provides noise isolation
from Outlet Banks 2 and 3.
BANK 2
SWITCHED
Note to CATV Installers:
This reminder is provided to call attention to Article 820-40 of the NEC. That article provides specific
guidelines for proper grounding.It specifies that the cable ground shall be connected to the grounding
system of the building and as close to the point of entry as practical.
Meter Dimmer
Pushbutton control for
Voltmeter
meter LED brightness.
Cycles between Off,
Digital LED voltmeter indicates incoming
Low, Medium and High.
line voltages between 90–140VAC.
VOLTS
METER
LIGHTS
Unsafe Voltage Indicator
Normally Off. Flashes to indicate that the incoming
line voltage is unsafe and the unit has disconnect-
ed the power to protect your equipment.
Power is
BANK 1
VOLTAGE SENSE
TRIGGER INPUT
ALWAYS ON
3 - 24VDC
Voltage Sense Trigger Input
3.5mm (1/8") Mini-Plug jack.
Connect to a remote trigger device
that uses a DC output to trigger a
startup/shutdown sequence. This
bypasses the front panel power
switch. Important, Please Note:
The unit needs to be plugged in,
and in the powered OFF state
before inserting the DC input trig-
ger mini-plug.
Convenience
Outlet
Provides a quick con-
venient way to plug in
components such as
camcorders and video
game systems.
Home Theater Power Conditioner
Satellite TV
Coax Jacks
Cable TV Coax Jacks
Bidirectional protection cir-
Bidirectional protection cir-
cuit optimized for satellite
cuit optimized for cable TV,
TV signal lines. Do not use
off-air antennas and cable
for cable TV off-air anten-
modem signal lines. Do not
nas and cable modems.
use for Satellite TV.
SATELLITE
CATV / ANT
SATELLITE 1
SATELLITE 2
CATV / ANT 1
LAN
LINE IN
EQUIP.
LINE IN
Phone Jacks
LAN Jacks
Protection
Protection circuits
standard telephone or pay-
for 10/100 baseT
Ethernet
lines.
per-view lines. Phone cir-
cuit
Incoming LAN line
Incoming
MUST be plugged
into the LINE jack.
MUST be plugged into the
LINE jack. Patch cords to
Patch cord to the
the equipment (satellite
equipment MUST
be plugged into
receiver,
recorder, telephone, etc.)
the EQUIP jacks.
MUST be plugged into the
EQUIP jacks.
CATV / ANT 2
PHONE
EQUIP.
circuits
for
is
auto-resetting.
phone
cord
digital
video
Advertisement
