Cleaning Spark Arrestor Screen - Honeywell HW1000i - Portable Inverter Generator Owner's Manual

Cleaning Spark Arrestor Screen

(HW2000i Model Only)
Muffler reaches temperatures that can cause serious
burns if touched. NEVER touch hot surfaces.
The generator muffler is equipped with a spark arrestor
screen, which must be cleaned according to the mainte-
nance schedule (Table 3).
To clean the spark arrestor screen, you will need:
‰ Screwdriver handle
‰ Screwdriver universal bit
‰ Wire brush
1. Stop the generator if the engine is running. Allow to
completely cool.
2. Place the generator on a flat, level surface.
Remove the muffler cover and spark arrestor screws
3.
using the Phillips end of the universal screwdriver bit.
FIGURE 32: Remove Spark Arrestor and Muffler Cover
4. Using the slotted end of the screwdriver universal bit,
loosen the spark arrestor by gently working it back
and forth on both sides being careful not to bend the
arrestor tabs.
Clean the spark arrestor screen using a wire brush.
5.
NOTE:
If the spark arrestor screws appear misaligned, rotate the
spark arrestor 180 degrees.
Reinstall the spark arrestor and muffler cover.
6.
HW1000i / HW2000i Inverter Generator Owner's Manual
Cleaning Spark Arrestor Screen
Cleaning Spark Arrestor Screen
Air Filter Maintenance
NOTICE
A dirty air filter will restrict air flow to the carburetor, which
may cause poor engine performance or damage.
Never run the generator without the air cleaner assembly
properly attached.
Clean the air cleaner filter every 50 hours of generator
operation. If the generator is operated in extremely dusty
areas, clean the air filter more frequently.
Gasoline and flammable solvents can cause fire or
explosion. NEVER use gasoline or flammable sol-
vent to clean air cleaner element.
• Use only household soap and water to clean the air fil-
ter.
To clean air filter, you will need:
‰ Screwdriver handle
‰ Screwdriver universal bit
‰ Household soap and water
‰ Clean, dry cloth
‰ Clean engine oil
Stop the generator if the engine is running. Allow to
1.
completely cool.
Remove back maintenance cover (A), air filter cover
2.
(B), and air filter (C).
FIGURE 33: Air Filter Removal (HW1000i Model)
www.honeywellgenerators.com 23