Loading Disc; Opening And Closing The Disc Tray; Selecting The Video Output - Denon ADV-M51 Operating Instructions Manual

ENGLISH

(2) Loading Disc

2 Set discs in the disc tray with the labeled (printed) side facing up.
8 cm disc guide
NOTE:
• Do not move the this unit while a disc is playing. Doing so
may scratch the disc.

(1) Opening and Closing the Disc Tray

q Turn on the power.
w Press the OPEN/CLOSE button.
NOTES:
• Even when the power is in the standby mode, when the
OPEN/CLOSE button is pressed, the ADV-M51's power turns
on and the disc tray operates. (Auto power on function)
• Even if the function is set to something other than DVD,
when the OPEN/CLOSE button is pressed, the function
switches to DVD and the disc tray operates. (Auto function
select function)
• Do not strike on the button with a pencil, etc.
(2) Loading Discs
• Pick up the disc carefully so as not to touch the signal surface and
hold it with the labeled side facing up.
• With the disc tray fully open, set the disc in the disc tray.
• Set 12 cm discs in the outer tray guide (Figure 1), 8 cm discs in the
inner tray guide (Figure 2).
• Press the OPEN/CLOSE button. The disc is automatically loaded.
• The disc tray can also be closed automatically to load the disc by
pressing the PLAY button.
Figure 1
Outer disc tray
40
12 cm disc guide
Disc tray
OPEN/CLOSE button
Disc tray
12 cm disc
Figure 2
Inner disc tray
8 cm disc
NOTES:
• If a foreign object is caught in the disc tray during closing,
simply press the OPEN/CLOSE button again and the tray will
open.
• Do not press the disc tray in by hand when the power is off.
Doing so will damage it.
• Do not place foreign objects in the disc tray. Doing so will
damage it.

(3) Selecting the video output

• Factory default: interlace, 525i.
• When a TV compatible with progressive 525p inputs is connected,
the setting can be switched using the operation described below.
1 With the function set to "DVD", press the MENU/SET
button for at least 2 seconds.
• The current setting ("INTERLACED" or "PROGRESSIVE")
is displayed after "VIDEO OUT".
2 Turn the surround/select control while the setting is
displayed to switch it.
• The setting switches alternately between "INTERLACED"
and "PROGRESSIVE".
• The normal display reappears if no operation is performed
for several seconds.
NOTE:
• When "PROGRESSIVE" is set, no video signals are output
from the VIDEO OUT or S-VIDEO OUT terminals. Set
"INTERLACED" if you want to use the VIDEO OUT or S-
VIDEO OUT signals.
MENU/SET
Main unit
SURROUND / SELECT
PUSH - PARAM.
Main unit