Toyota CAMRY-2002 Owner's Manual page 228

—Removing wheel ornament
(steel wheels only)
3. Remove the wheel ornament.
Pry off the wheel ornament, using the
beveled end of the wheel nut wrench as
shown.
CAUTION
Do not try to pull off the ornament by
hand. Take due care in handling the
ornament to avoid unexpected person-
al injury.
220
AP_Camry_U (L/O 0201)
—Loosening wheel nuts
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before rais-
ing the vehicle.
Turn the wheel nuts counterclockwise to
loosen. To get maximum leverage, fit the
wrench to the nut so that the handle is
on the right side, as shown above. Grab
the wrench near the end of the handle
and pull up on the handle. Be careful that
the wrench does not slip off the nut.
Do not remove the nuts yet—just unscrew
them about one–half turn.
2002 MY CAMRY_U (OM33567U)
—Positioning the jack
5. Position the jack at the correct jack
point as shown. Rotate the load rest
90A from storage position to lifting
position.
Make sure the jack is positioned on a
level and solid place.