Toyota CAMRY-2002 Owner's Manual page 180

(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
172
AP_Camry_U (L/O 0201)
B
CAUTION
A
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
B
rage door or other device to pre-
vent potential harm or damage.
A
Do not use this HomeLink
sal Transceiver with
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any garage
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
2002 MY CAMRY_U (OM33567U)
FCC ID: CB2300NHL3
CANADA: 2791032088
B
This device complies with FCC Rules
Part 15. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence that may be received, including
interference that may cause undesired
B
Univer- operation.
any garage
WARNING: This transmitter has been
tested and complies with FCC and
DOC/MPAC rules. Changes or modifi-
cations not expressly approved by the
door
partly responsible
could void the user's authority to op-
erate the device.
for compliance