Advertisement
Advertisement
Related Manuals for fomex HD600
Summary of Contents for fomex HD600
- Page 1 User Manual HD SERIES HD150 / 200 / 400 / 600 / 900 / 1000 / 1200...
-
Page 2: Before Using
Before using 1. Be sure to use the lighting only after understanding manual. 2. Check the power input voltage 3. Do not move it nor give impact while the power is on (Lamp filament can become disconnected) 4. Be sure to use the grounded socket as a power. 5. -
Page 3: Table Of Contents
Procedure page Before using Name of each part Name and function of control panel Operating way Specifications Method of managing and keeping Countermeasure on breakdown HD SERIES... -
Page 4: Name Of Each Part
Name of each part ① ① Protection cap ⑥ Lighting knob ② Modeling(Halogen) lamp ⑦ Stand stud joint fastening bolt ③ Flash tube(Xenon tube) ⑧ Stand stud joint part ④ Accessory disassembling and ⑨ Prop fastening bolt assembling locking knob ⑩... -
Page 5: Name And Function Of Control Panel
Name and function of panel ① Sound ON/OFF button : It makes signal sound on flash electrification or electric discharge. ② Test PUSH button : It’s pressed on flash electric discharge or flash test. ③ Flash power control volume : It controls power of flash(strobe). ④... -
Page 6: Operating Way
Operation 1. When released from the factory, halogen control volume is in off position. 2. Fit the modeling lamp into the lighting. 3. After checking if modeling lamp control volume(MODEL) of control panel and output control volume are at minimum position and if power switch is OFF, connect the power cord to input socket. -
Page 7: Specifications
Specifications Model HD150 HD200 HD400 HD600 HD900 HD1000 HD1200 Item Maximum Output(W/s) 1000 1200 Input Voltage AC 110/220V 50/60Hz Charging Time(sec) 0.1~1.0 0.1~1.2 0.2~1.5 0.2~1.5 0.3~1.8 0.3~2.0 0.3~2.5 F5.6 ~F45 F8~F64 ~F64 F2.8~F22 F2.8 ~F22 ~F32 F5.6~F45 Power Control Range... -
Page 8: Method Of Managing And Keeping
Directions for replacing parts 1. Replacing the modeling lamp (BASE: GX-6.35) - After cooling the lamp enough, maneuver it left and right to separate it from the socket. - Maneuver the new lamp left and right to install it onto the socket. - Be careful not to let any finger print or dust stain the lamp, and clean the lamp with soft cloth or tissue lightly dampened with alcohol after replacing the lamp. -
Page 9: Countermeasure On Breakdown
Countermeasure on breakdown Status Expected cause Point of checking and action Slave is Slave button is turned OFF. Check if slave button is turned ON. impossible. Slave sensor is out of the light After turning the lighting by 180° so as of flash. - Page 10 MEMO HD SERIES...
- Page 11 MEMO HD SERIES...
Need help?
Do you have a question about the HD600 and is the answer not in the manual?
Questions and answers