Hargrove Western Pine Operation And Installation Manual

This appliance is
designed to supplement
a current heating
system. It is not
designed to be used as
a primary heat source.
WARNING: Improper installation, adjustments, alteration,
service, or maintenance can cause personal injury or
property damage. Refer to this manual. For assistance
or for additional information, consult a qualified installer,
service agency or gas supplier.
WARNING: If information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
-
 Do not try to light any appliance.
 Do not touch any electrical switch; do not use any phone in your building.
 Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
 If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
HARGROVE
Classic Oak & Western Pine
Vent Free Room Heater
Operation and Installation Guide
Classic Oak 24" Set
This appliance operates as an unvented
room heater when fitted to a solid fuel
burning masonry or UL127 approved
factory built fireplace with the flue
damper closed. It may also be installed
in an approved unvented fireplace.
Western Pine 24" Set
WARNING: THIS IS AN UNVENTED GAS FIRED
HEATER. IT USES AIR (OXYGEN) FROM THE
ROOM IN WHICH IT IS INSTALLED. PROVISIONS
FOR ADEQUATE COMBUSTION AND VENTILATION
AIR MUST BE PROVIDED. REFERENCE NATIONAL
FUEL GAS CODE NFPA 54, ANSI Z223.1. REFER TO
PAGE 2 OF THE INSTALLATION INSTRUCTIONS.
This appliance is only for use with the type of gas indicated on
the rating plate. This appliance is not convertible for use with
other gases. Solid fuels shall not be burned in a fireplace
where an unvented room heater is installed.
Natural Gas
and Propane
(LP) Models