Lexicon PCM 80 - REV 1 DUAL FX User Manual page 62

0.5 4PoleRvb BP
A large chamber reverb feeding into a stereo, 24dB/octave bandpass filter. ADJUST
controls the center frequency of the band. Use it to focus the reverb around a tight tonal
area — try it with different percussion instruments. The Soft Row contains reverb controls.
0.6 4PoleRvb HP
A large chamber reverb feeding into a stereo, 24dB/octave highpass filter. ADJUST
controls the low frequency cutoff. Use it to put reverb on only the upper frequency portion
of a stereo source or mix. The Soft Row contains reverb controls.
0.7 4PoleRvb LP
A large chamber reverb feeding into a stereo, 24dB/octave lowpass filter. ADJUST
controls the high frequency cutoff. Use it to put reverb on only the lower frequency portion
of a stereo source or mix. This preset is also great for simulating backstage ambient
effects. The Soft Row contains reverb controls.
0.8 Chorus>Rvb 1
Stereo chorus into stereo hall reverb. ADJUST controls the amount of reverb in the
chorused signal. T
0.9 Chorus>Rvb 2
A variation of Chorus>Rvb1. In this preset, eighth-note delays have been added.
ADJUST controls the amount of reverb in the chorused signal. The Soft Row contains
delay controls. T
1.0 Rvb>Chorus 1
The reverse of Chorus>Rvb 2. The reverb output is routed into a stereo chorus. Notice
the chorus effect on the reverb tail. ADJUST controls the wet/dry mix of the signal sent
into the chorus/delay. T
1.1 Auto Pan Rvb
The output of a medium chamber is panned across a stereo low-pass filter. Use ADJUST
to dial in the high frequencies.
1.2 Knob Pan Rvb
Another reverb panning effect. In this variation, use ADJUST to pan the reverb image to
any location between left and right. 0=left, 100=right.
1.3 FilterPanner
A panning effect based on filter frequency instead of level. The high-cut frequencies of
the left and right channels are swept 90° out-of-phase to produce apparent left-right
motion in the audio. The rate of the sweep is tempo controlled. ADJUST controls the side-
to-side width of the panning effect. T
1.4 EQ'd Rvb HP1
A stereo chamber reverb followed by a stereo high-pass filter. ADJUST controls the filter
frequency.
1.5 EQ'd Rvb HP2
A variation of EQ'd Rvb HP1. This version has a more resonant high-pass filter.
1.6 EQ'd Rvb LP
A stereo chamber reverb followed by a stereo low-pass filter. The filter is resonant, like
EQ'd Rvb HP2. ADJUST controls the filter frequency.
1.7 EQ'd Rvb BP
A stereo chamber reverb followed by a stereo bandpass filter. ADJUST controls the filter
frequency.
ADJUST: Center
ADJUST: LoCut
ADJUST: HiCut
ADJUST: Rvb Mix
ADJUST: Rvb Mix
ADJUST: Rvb Mix
ADJUST: Hi Cut
ADJUST: Pan
ADJUST: PanWidth
ADJUST: Sizzle
ADJUST: Sizzle
ADJUST: Boom
ADJUST: Band
0–127
0–127
0–127
0–100
0–100
0–100
0–100
0–100
0–100
0–127
0–127
0–127
0–127
The Presets
3-7