Lexicon MPX 500 V2 - UPGRADE Installation Instructions Manual page 20

MPX 500 Version 2 Software Release Notes
Flange Parameters
Speed
Depth
Sweep
Phase
Detune Parameters
Tune 1, Tune 2
Pitch Parameters
Pch, Intrvl
PDly
Pch Fbk
-L-, -R/S-
continued on next page
20
Controls how rapidly the two Flange voices move.
Controls how much Flange effect is created by adjusting the level of the two Flange voices.
Determines the maximum amount of time-delay applied to each voice.
Determines the relative timing between the speed modulation of the two voices.
Determines the amount of detuned signal mixed into output.
Controls the amount of pitch shift applied. Interval values are in semitones, Pitch values are
in Cents (1/100th of a semitone). These values are additive.
Used to control the amount of "look-ahead" required by the pitchshift algorithm. Good
performance requires some amount of predelay, so this control cannot actually set the
PreDelay to zero.
Controls the level of feedback looping around the pitch algorithm, allowing for manipulation
of pitch shifts to create dynamic special effects.
Designations on the Pitch parameters that mean "Left" or "Right/Stereo". Pitch shifting requires
some time shifting. A true stereo (not merely dual-mono) signal contains components that
are common to L and R. A proper stereo image is maintained only if the phase relationship
between these signals is maintained, which requires that the exact same computations be
applied to both channels.
Lexicon, Inc.