Advertisement
Intrusion Sensor
An intrusion sensor consists of two parts: a magnet and an
electrical switch. The magnet should be installed on the inside of
the rack door and the electrical switch on the rack as shown
below. Make sure the magnet and switch align; allow sufficient
clearance for the doors to close. The intrusion sensors should be
installed on the front door
door
.
9000 series rack
1
7000 series rack
1
of the rack, as well as the rear
2
2
The intrusion sensor is delivered with a terminating plug in the
upper connector. The terminating plug must be connected as
shown. To daisy-chain multiple intrusion sensors to a single CMC
port, the terminating plug
the next intrusion sensor in line
1
Mechanical Shock/Vibration Sensor
The mechanical shock/vibration sensor should be installed on the
rails of the rack.
9000 series rack
7000 series rack
must be removed and the plug from
connected in its place.
2
Advertisement
