C
ONSOLE
M
ANAGEMENT
C
ONTROLLER
S
S
MOKE
Installation Instructions
Read Instructions Completely Before
Beginning Installation Procedures
Printed on recycled paper
NOTICE
©
2001 Compaq Computer Corporation
Compaq, the Compaq logo Reg. U.S. Pat. & Tm. Off.
Compaq shall not be liable for technical or editorial errors or omissions contained
herein. The information in this document is provided "as is" without warranty of any
kind and is subject to change without notice. The warranties for Compaq products are
set forth in the express limited warranty statements accompanying such products.
Nothing herein should be construed as constituting an additional warranty.
COMPAQ CONSOLE MANAGEMENT CONTROLLER SMOKE SENSOR KIT
INSTALLATION INSTRUCTIONS
First Edition (June 2001)
Part Number 240829-021
240829- 021
K
ENSOR
IT
About This Device
These instructions serve as an outline to assist qualified personnel with
the installation of the smoke sensor option for the Compaq Console
Management Controller (CMC).
This sensor receives 24VDC power from the CMC and provides an
alarm signal output. This alarm is activated if smoke is detected or if the
fan speed falls out of range.
This smoke sensor is used with certified information technology
equipment.
Important Safety Information
Read Before Installing Product
Please refer to the Important Safety Information (guide included with
this option kit) before installing this product.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This document contains important
instructions for the CMC Smoke Sensor kit that should be followed
during installation.
Kit Contents
n Smoke sensor
o Sensor module (1)
o Sampling tube (4 sections)
o Tube couplings (4)
o End cap (1)
n Mounting hardware
o Tube bracket
o Screws
o Washers
o Nut
n Sensor cable (RJ-12 to RJ-12)