Compaq 203039-B21 - Console Management Controller Quick Installation Manual

C
ONSOLE
M
ANAGEMENT
C
ONTROLLER
Quick Installation Guide for
Rack-Mounted Console Management Controller
Open Guide Completely Before
Beginning Installation Procedures
Printed on recycled paper
NOTICE
The information in this publication is subject to change without notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR
TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN,
NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM
THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. THIS
INFORMATION IS PROVIDED "AS IS" AND COMPAQ COMPUTER
CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED OR
STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF
MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE
AND AGAINST INFRINGEMENT.
This publication contains information protected by copyright. No part of
this publication may be photocopied or reproduced in any form without
prior written consent from Compaq Computer Corporation.
©
2000 Compaq Computer Corporation
Compaq, Registered U.S. Patent and Trademark Office.
COMPAQ CONSOLE MANAGEMENT CONTROLLER KIT
First Edition (December 2000)
Part Number 218260-021
Compaq Computer Corporation
K
IT
218260- 021
About This Device
This guide serves as an outline to assist qualified personnel with the installation
of the Compaq Console Management Controller (CMC).
The input voltage for this CMC is 100VAC to 240VAC, 50/60 Hz. This CMC
includes the following features:
n Mounts in a 1U configuration.
n Provides monitoring and environmental control for single or multiple rack
suites.
This CMC is used with certified information technology equipment.
Regulatory Compliance Information
All regulatory certifications for this product was obtained under the following
agency series number. The corresponding part model number is shown.
n 203039-B21
/ EO3009
(part number)
Important Safety Information
Read Before Installing Product
Please refer to the Important Safety Information (guide included with the CMC
kit) before installing this product.
WARNING: There is a risk of personal injury from electrical shock and
hazardous energy levels. The installation of options and routine maintenance
and service of this product must be performed by individuals who are
knowledgeable about the procedures, precautions, and hazards associated
with AC power products.
IMPORTANT: Only use the power cords supplied with your CMC. If the CMC does not
include a power cord that is suitable for your application, contact an
authorized Compaq service representative to obtain the appropriate
power cord. See the "Precautions for Power Products" section of the
Important Safety Information (guide included with the CMC kit.)
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This Quick Installation Guide contains
important instructions for the rack-mounted CMC that should be followed
during installation.
Kit Contents
n Console Management Controller
n Input power cord (country specific)
n Voltage monitor cord/fan input cord (country specific)
n Jumper power cords (3) for two fan assemblies and main input power via UPS
(IEC 320 to IEC 320)
n Temperature sensor
n Intrusion sensors (2)
n Network cable (RJ-45 to RJ-45)
n Serial communication cable (RJ-11 to DB9)
n RJ-12 to pigtails (2) for relay output connectors on rear of unit
n Tie wraps and cord management clips
n Mounting hardware
o Screws
o Cage nuts
o Double sided tape
n Cord retention bracket
n Package of sensor cables
(agency series number)