Class A Equipment; Class B Equipment - Compaq 222863-001 - TaskSmart W2200 Model 10 System Reference Manual

A-2 Compaq TaskSmart W2200 Appliance Server System Reference Guide

Class A Equipment

Class B Equipment

The FCC requires devices in both Classes to bear labels indicating the
interference potential as well as additional operating instructions for the user.
The rating label on the device shows the Class (A or B) into which the
equipment is categorized. Class B devices have a FCC logo or FCC ID on the
label. Class A devices do not have an FCC logo or FCC ID on the label. After
determining the Class of your device, refer to the corresponding Class
statements.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user must correct the
interference at personal expense.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined when the equipment is turned
off and on, the user is encouraged to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.


Increase the separation between the equipment and the receiver.


Connect the equipment to an outlet on a circuit different from that to


which the receiver is connected.
Consult the dealer or an experienced radio or television technician


for help.