Table of Contents
Advertisement
•
Ensure rubber deflectors are in position and not
damaged. Replace worn, broken, and missing
sections immediately.
•
Ensure the rollers are in good condition and
rotate freely.
•
Inspect that all bolts and screws are in position.
OPS-F-0070
•
Inspect the condition of the drive belts.
•
Ensure the slip clutch (rear mower section only)
is properly adjusted and the friction plates are
not frozen together. Reference the
Maintenance Section for proper slip clutch
maintenance.
•
Ensure the slop clutch shield and drive belts
shields are in place and in good repair.
•
Ensure the tractor PTO master shield is in
place, lowered and in good condition.
OPS-F- 0016
•
Inspect cutter knives and knife pins for
looseness and excessive wear. Make sure the
mower is securely blocked up before crawling
beneath. Replace damaged, worn, and missing
knives as complete sets to maintain cuttershaft
balance.
•
Remove any grass or other debris which may
be wrapped around the cuttershafts.
•
Inspect the condition of deck skid shoes and
hardware. OPS-F- 0007
HYDRO 88 & 96 03/09
©2009 Alamo Group Inc.
OPERATION
Operation Section 4-15
Advertisement
Table of Contents
