Cisco NSS2000 - Gigabit Storage System Chassis Release Notes page 6

Release Notes
Closed Caveats
6
Resolved in Firmware Version 1.16
• CSCsv34671
When the Network Access Filter is set to Policy=Drop Traffic and
Filter=AllowAll or Policy=Drop and Filter=AllowCIFS, the CIFS mount
now works.
• CSCsv34675
When the Network Access Filter is set to Filter=AllowHTTPS and
Filter=DropFTPS, you can now add Network Access from the
Configuration GUI.
• CSCsv34906
When a RAID0 array failure occurs, an alert (SNMP trap, email or system
alert) is now triggered.
• CSCsv46326
When a Seagate 1 terabyte (TB) hard drive (model ST31000340AS) is
installed in the NSS, it is not detected by the system on bootup or when
hotplugging the drive.
There is no workaround. This drive is not compatible with the NSS2000.
For a current list of compatible disk drives, see the Cisco Approved Vendor
List for Network Storage Systems at:
products/ps9957/prod_technical_reference_list.html
• CSCsv46327
When Seagate hard drives are installed in the NSS, they are now
immediately detected on bootup.
• CSCsv46993
The maximum transmission unit (MTU) size of the NSS is now supported.
• CSCsv47120
If a user was granted write access to a share and the write access was
revoked, the user can no longer write to subfolders by using FTP.
http://www.cisco.com/en/US/
Release Notes for the NSS2000 Series Firmware Version 1. 1 6