Cisco PIX-515E Quick Start Manual page 33

Ethernet 5
Ethernet 3
Ethernet 2
Ethernet 4
Ethernet 2
Ethernet 3
• If your PIX 515E has one or two single-port Ethernet circuit boards installed in the
auxiliary assembly on the left of the unit at the rear, the circuit boards are numbered top
to bottom so that the top circuit board is Ethernet 2 and the bottom circuit board is
Ethernet 3. (Using more than one Ethernet circuit board requires the
PIX 515E-unrestricted license for access. If a four-port FE card is used with the restricted
license, only one network interface is activated.)
If you need to install an optional circuit board, refer to the
Note
PIX 515E" section in the Cisco PIX Firewall Hardware Installation Guide.
If you have a second PIX 515E to use as a failover unit, install the failover feature and cable
as described in the
Installation Guide.
100 Mbps Link
FDX 100 Mbps FAILOVER
Link
FDX
10/100 ETHERN ET 0/0
10/100 ETHERN ET 0/0
CONSO LE
Ethernet 1
Ethernet 0
100 Mbps
Link
FDX 100 Mbps FAILOVER
Link
FDX
10/100 ETHERN ET 0/0
10/100 ETHERN ET 0/0
CONSO LE
Ethernet 1
Ethernet 0
"Installing Failover" section in the Cisco PIX Firewall Hardware
"Installing a Circuit Board in the
33