Advertisement
Table of Contents
BUILT BETTER THAN IT HAS TO BE"
Installation
Instructions
Top Loading
Washer
Keep instructions
for future
reference.
Be sure manual
stays with washer.
MOVE
WASHER
TO FINAL
AREA;
REMOVE
SHIPPING
BRACE
& PLUG
Protect the floor when moving the
washer. Washer must be within 4 feet
of desired area before beginning
installation. Open washer lid and
remove installation parts from
shipping brace for use.
Reach through foam shipping
brace, grasp bottom of brace, and
pull up to remove.
i
NOTE: Save shipping plug and
shipping brace; reinstall whenever
washer is moved more than 4 feet.
Do not lift or move washer without
shipping materials in place.
To remove the shipping plug from the
washer, step on the card board base,
tilt the washer back, and slide out the
base.
i
Cardboard
base
Shipping
brace
Shipping
plug
CONNECT
WATER
FILL
HOSES
TO
WASHER
Tightly push one flat rubber
washer into one end of each
water fill hose and attach this end
of hose to washer. HOT and
COLD connections are identified
by letters H and C stamped into
washer cabinet and by HOT and
COLD printed on water fill hoses.
In most cases, hoses should
cross when attached to correct
water temperature faucet.
]]ghten hose connections by hand
until snug, then another ¼ turn with
pliers. DO NOT cross-thread or over-
tighten couplings.
end of fill hose.
Advertisement
Table of Contents
Related Manuals for Amana NAV5800AWW
Summarization of Contents
Move Washer to Final Area
Remove Shipping Brace & Plug
Remove shipping brace and plug, protecting the floor during movement.
Connect Water Fill Hoses to Washer
Identify HOT and COLD Connections
Connect water fill hoses to washer, ensuring correct HOT/COLD identification.
Connect Water Fill Hoses to Faucets
Flush Lines and Check for Leaks
Flush faucet lines, connect hoses, and tighten securely, checking for leaks.
Secure Drain Hose to Drain
Prevent Siphoning
Secure drain hose to standpipe/tub, avoiding an air-tight seal to prevent siphoning.
Position and Level Washer
Level Front Legs
Adjust front leveling legs to ensure the machine is level side-to-side.
Level Rear Legs
Tilt washer forward to correctly set rear self-leveling legs.
Connect Power Cord to Electricity
Grounding Requirements
Plug washer into a 3-prong grounded outlet only.
Clean Tub and Run Cycle
Pre-Use Cleaning
Clean the tub with soap and water and run a cycle before first use.
Important Safety Information
About Ground Wires
Explains the purpose and use of ground wires for electrical safety.
Grounding Instructions
Provides instructions on proper grounding of the washer to prevent electric shock.
Installation Requirements
Location
Specifies requirements for washer placement, including floor type and stability.
Electrical Requirements
Details the necessary voltage, amperage, and plug type for electrical connection.
Water Supply Faucets
Specifies the type of water supply faucets required for hose connections.
Water Pressure
States the acceptable range of water pressure for proper washer operation.
Drain
Outlines requirements for the drain receptacle and hose height.
Need help?
Do you have a question about the NAV5800AWW and is the answer not in the manual?
Questions and answers