Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Camco D-POWER 2
Summarization of Contents
IMPORTANT SAFETY INSTRUCTIONS
General Safety Precautions
Reading manual, safekeeping, following instructions, cleaning, proper use, placement, disconnection, and servicing.
Environmental and Installation Safety
Avoiding moisture, liquids, heat, and ensuring proper ventilation during installation.
Power Cord Safety
Protecting the power cord from damage.
EXPLANATION OF SYMBOLS AND SAFETY
Safety Symbols Guide
Explanation of electrical hazard and warning symbols used in the manual.
Safe Operation Practices
Guidelines for shipping, environments, ventilation, water, and cleaning procedures.
WELCOME
Company Introduction
Introduction to CAMCO's experience and product reputation.
Unpacking and Shipping Procedures
Instructions for unpacking, inspecting for damage, and saving packing materials.
FACILITIES
Front Panel Overview
Identification and description of front panel controls and indicators.
Rear Panel Overview
Identification and description of rear panel connections and switches.
Factory Default Settings
Default settings for volume, ground lift, mode, gain, and limiter.
INSTALLATION
Mains Connection and Power Switch
Connecting to AC power and using the power switch.
Mounting, Cooling and Ground Lift
Rack mounting, airflow, and ground lift switch for XLR connections.
Operating Modes Selection
Setting the amplifier operating mode (Stereo, Parallel-Mono, Mono-Bridge).
Wiring and Speaker Connections
Connecting speakers via XLR and SPEAKON connectors.
OPERATION
Front Panel Controls
Volume, Gain Selector, Gain/Sensitivity, and Limiter switch controls.
Indicator Lights Explained
Explanation of Power, Signal, I-Out, Clip, and Mode LEDs.
High Pass Filter (HPF) Function
Settings and frequency response curves for the High Pass Filter.
Amplifier Protection Systems
Details on clip limiter, SOA, DC, over current, thermal, and mains protections.
Fan Operation and Filter Cleaning
Fan speed control and procedure for cleaning the air filter.
Optional Volume Control Cover
Optional accessory for protecting volume controls.
TROUBLESHOOTING
No Sound Diagnosis
Diagnosing and resolving no sound problems based on LED indications.
Channel Separation and Distortion Issues
Troubleshooting lack of separation and causes of distorted sound.
Hiss and Feedback Solutions
Addressing hiss and microphone feedback issues.
SPECIFICATION
Output Power and Circuitry Details
Power output specifications and circuitry type.
Electrical and Noise Specifications
Power consumption, signal-to-noise ratio, and frequency response.
Physical Dimensions and Weight
Physical dimensions and weight of the amplifier.
TYPICAL PERFORMANCE DIAGRAMS
Gain and Phase Response Graphs
Illustrates gain and phase response across frequencies and with HPF settings.
Output Impedance and Damping Factor
Graphs showing output impedance and damping factor characteristics.
Distortion, Noise and CMRR Graphs
THD+N, noise, CCIF, SMPTE distortion, and CMRR performance.
Output Power vs. Impedance Charts
Bar charts showing peak and distortion-limited output power.
WARRANTY INFORMATION
Warranty Coverage and Exclusions
Details on the warranty period, coverage, and excluded damages.
Obtaining Warranty Service
Procedure for requesting warranty service and shipping requirements.
Product Improvement Policy
CAMCO's right to improve products without prior notice.
SERVICE INFORMATION
Service Request Form Completion
Form for providing owner, problem, and shipping information for service.
Maintenance and Decommissioning
Guidelines for qualified maintenance and decommissioning procedures.
COMPANY INFORMATION
Contact and Mailing Details
Mailing address, telephone, facsimile, internet, and email for CAMCO.
Need help?
Do you have a question about the D-POWER 2 and is the answer not in the manual?
Questions and answers