Yaesu VX-170 - APRS Manual page 80

( M
S
ET ENU
Function: Selects the Memory Scan channel-selection mode.
Available Values: ONLY/MEM
Default: MEM
ONLY: The scanner will only scan channels that are flagged (Preferential Scan List).
MEM: The scanner will "skip" the flagged channels during scanning.
Set Mode Item 40 [ SCN.LMP ]
Function: Enables/Disables the Scan lamp while paused.
Available Values: ON/OFF
Default: ON
Set Mode Item 41 [ SHIFT ]
Function: Sets the magnitude of the repeater Shift.
Available Values: 0.00 - 99.95 MHz (50 kHz increments)
Default: Depends on the operating band and transceiver version.
Set Mode Item 42 [ SKIP ]
Function: Selects the Memory Scan "Skip" channel-selection mode.
Available Values: OFF/SKIP/ONLY
Default: OFF
SKIP: The scanner will "skip" the flagged channels during scanning.
ONLY: The scanner will only scan channels that are flagged (Preferential Scan List).
OFF: All memory channels will be scanned (the "flag" will be ignored).
Set Mode Item 43 [ SPLIT ]
Function: Enables/Disables split CTCSS/DCS coding.
Available Values: SPL.OFF/SPL. ON
Default: SPL.OFF
When this Set Mode Item is set to "SPL. ON," you will see the following additional param-
eters after the "DCS" parameter while configuring Set Mode Item 44:
D: DCS Encode only.
T DCS: Encodes a CTCSS tone and Decodes a DCS code.
D TSQL: Encodes a DCS code and Decodes a CTCSS tone.
Select the desired operating mode from the selections shown above.
Set Mode Item 44 [ SQL.TYP ]
78
) M
ODE
SQL.TYP SQL.TYP SQL.TYP
SQL.TYP SQL.TYP
VX-170 O
PERATING
.
M
ANUAL