A1A Cw Auto; A1A Bfo; A1A Bk-In; A1A Delay - Yaesu FT-950 - MENU MODE LIST Manual

M M
ENU ODE

041 A1A CW AUTO

Function: Enables/disables CW keying while operating
on SSB.
Available Values: OFF/50/On
Default Setting: OFF
OFF: Disables CW keying while operating on SSB.
50: Enables CW keying only while operating SSB on 50
MHz (but not HF).
On: Enables CW keying while operating on SSB (all TX
bands).
N :
OTE
This feature allows you to move someone from SSB to
CW without having to change modes on the front panel.

042 A1A BFO

Function: Sets the CW carrier oscillator injection side for
the CW mode.
Available Values: USb/LSb/Auto
Default Setting: USb
USb: Injects the CW carrier oscillator on the USB side.
LSb: Injects the CW carrier oscillator on the LSB side.
Auto: Injects the CW carrier oscillator on the LSB side
while operating on the 7 MHz band and below, and
the USB side while operating on the 10 MHz band
and up.

043 A1A BK-IN

Function: Sets the CW "break-in" mode.
Available Values: SEni/FuLL
Default Setting: SEni
SEni (SEMI): The transceiver will operate in the semi
break-in mode. The delay (receiver recovery) time is set
via the Menu item "044 A1A DELAY

044 A1A DELAY

044 A1A DELAY". 044 A1A DELAY
044 A1A DELAY
FuLL: The transceiver will operate in the full break-in
(QSK) mode.
044 A1A DELAY
Function: Adjusts the Keying Delay (receiver recovery)
time on the CW mode.
Available Values: 30 ~ 3000 msec (10 msec/step)
Default Setting: 200 msec
Page 112
MODE-CW G
ROUP
045 A1A PITCH
Function: Adjusts your preferred CW tone pitch.
Available Values: 300 ~ 1050 Hz (50 Hz/step)
Default Setting: 700 Hz
046 A1A WEIGHT
Function: Sets the Dot:Dash ratio for the built-in elec-
tronic keyer.
Available Values: (1:) 2.5 ~ 4.5
Default Setting: 3.0
047 A1A FRQDISP
Function: Selects the frequency Display Format for the
CW mode.
Available Values: dir/OFSt
Default Setting: OFSt
dir (Direct Frequency): Displays the receiver carrier fre-
OFSt (Pitch Offset):
048 A1A PC KYNG
Function: Enables/disables CW keying from the "DATA
PTT" terminal (pin 3) on the rear panel's RTTY/PKT jack
while operating on the CW mode.
Available Values: EnA (Enable)/diS (Disable)
Default Setting: diS (Disable)
049 A1A QSKTIME
Function: Selects the time delay between when the PTT
is keyed and the carrier is transmitted during QSK opera-
tion when using the internal keyer.
Available Values: 15/20/25/30 msec
Default Setting: 15 msec
quency, without any offset added.
When changing modes between
SSB and CW, the frequency dis-
play remains constant.
This frequency display reflects the
added BFO offset.
FT-950 O
PERATING
M
ANUAL